Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Rods AB and AC have a diameter of 20 mm and are made of 6061-T6 aluminum alloy. They are connected to the rigid collar A which slides freely along the vertical guide rod. If the 50-kg block D is dropped from height h = 200 mm above the collar, determine the maximum normal stress developed in the rods.
What is the smallest particle size (density 2.65 g/cm3) that will be removed in a horizontal grit chamber 10 m long and 1.0 m deep if the flow rate is 1000 m3/hr. Assume the temperature of the water is 25°C.
The heat exchanger consists of 12 m of copper tubing that is 2 cm in diameter with 19 return bends. The flow rate is 3 x 10-4 m3/s. Water enters at 20 C and exits at 80 C. The elevation difference between the entrance and the exit is 0.8 m.
A simply supported beam, 2 inches wide by 4 inches high and 12 feetlong is subjected to a concentrated load of 2000 lb at a point 3 ftfrom one of the supports. Determine the maximum fiber stress and the stress in a fiber located 0.5 inches from the t..
If the maximum allowable compressive stress of timber is 7MPa, what is the minimum available size of square section post required. (give dimensions as well as area). Please show working.
Design a suitable compression member and Tension capacity of UB section and plates and Check the structural capacity under pure tension
A Ferris wheel with a radius of 35 feet starts from rest and undergoes an angular acceleration of 0.05 rad/s^2. Compute the magnitude of the velocity and acceleration vectors at 5 seconds for a point on the rim of the Ferris wheel.
Recommend the friction angle to be used for the foundation design of a 10-story-high building. Explain your recommendation.
If the weight flowrate into the elbow is 47 lbf/s, find the mass flowrate out of the elbow, the volume flowrate in and out of the elbow, and the average velocity in and out of the elbow.
Determine the deflection at the mid span of a simple beam (wood joist) of a row house. The joist is designed as 2x12@16'' for DL = 12psf and LL=40 psf. The span length of the joist is 18'
Similar to Problem 27.19, except the air base is 6940 ft, the flying height above mean sea level is 12,520 ft, the x and y photo coordinates on the left photo are xa = 37.98 mm, ya = 50.45 mm, xb = 24.60 mm, and yb = -46.89 mm, and the x photo coo..
To maintain a pressure of 300kPa at point 2, what the 15 C water is flowing at 0.5 L/s, what pressure must be provided at point 1 if you neglect friction
For a trapezoidal shaped channel (n=0.014 and slope = 0.0002 with a 20-ft bottom width and side slopes of 1:1.5 (V:H), determine the normal depth using trial and error technique for a discharge of 1000 cfs.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd