Determine the maximum force p that can be applied without

Assignment Help Civil Engineering
Reference no: EM13557065

Determine the maximum force P that can be applied without causing the two 50-kg crates to move. The coefficient of static friction between each crate and the ground is 0.25 The crates are next to each other connected by a rope and then from the other end one has a P force going up at an angle of 30 degrees

Reference no: EM13557065

Questions Cloud

What is the concentration of bod in the river-wastewater mix : Compare the monolithic approach, the layered approach, and the microkernel approach in terms of degree of difficulty to debug, portability, efficiency, and degree of structure.
How much heat energy is radiatred from each of the disk : Given the heat transfer of the disk rotor is 120 W/m2/K, how much heat energy is radiatred from each of the disk rotors when the ambient air temperature is 30 C
What is the concentration of particles in the air : A hi-vol clean filter weighs 18.00 g. After a 24 hour sampling period the filter is removed and weighs 18.65 g. The initial flow rate through the filter was 2.5 m3/min. When the filter was removed the flow rate through the filter was 1 m3/min. What i..
Determine the magnitude of the force of the rod on the : Using a forked rod, a smooth cylinder C having a mass of 0.5 kg is forced to move along the vertical slotted path r = 0.5? m, where ? is in radians. If the angular position of the arm is ?
Determine the maximum force p that can be applied without : Determine the maximum force P that can be applied without causing the two 50-kg crates to move. The coefficient of static friction between each crate and the ground is 0.25 The crates are next to each other connected
Find the required energy input ep and p to be supplied by : Find the required energy input Ep and ?p to be supplied by the pump. Assume the electric motors are set to turn the centrifugal pump impeller at ? = 4000 rpm
Determine the velocity as a function of position : A spherical pressure vessel has an outer diameter of 10 ft and a wall thickness of 0.5 in. knowing that for the steel used ?all= 12 ski, E= 29 x 10^6 psi, and v= 0.29, determine (a) the allowable gage pressure, (b) the corresponding increase in the d..
Obtain estimates of the pressure using the vander waals : Consider high pressure steam at 400 degrees C and v =0.01567 m^3/kg. Obtain estimates of the pressure using
Find the maximum load p that can be applied as shown : The 4-mm diameter cable BC is made of a steel with E= 200 GPa. Knowing that the maximum stress in the cable must not exceed 190 MPa and that the elongation of the cable must not exceed 6mm, find the maximum load P that can be applied as shown.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the forces fx and fy necessary to hold the pipe

Water flows steadily through a horizontal 30 degree upward bend. The inlet diameter is 0.3 m, the velocity is 12 m/s, and the pressure is 128 kpa gage. The outlet diameter is 0.38 m and the pressure is 145 kpa gage.

  Determine the friction and the head loss with linear length

A 8 inch polyethylene pipe has a flow rate of 1000 gallons/minute with a linear length of 10000ft. Starting at elevation 200ft then ends at 600ft elevation. Initial pressure is 40 psi. find the friction and the head loss.

  Determine the deflection at the mid span of a simple

Determine the deflection at the mid span of a simple beam (wood joist) of a row house. The joist is designed as 2x12@16'' for DL = 12psf and LL=40 psf.

  What must the hydraulic detention time be in the aeration

A perfectly mixed aeration pond with no recycle (return line) serves as the biological reactor for a small community. The pond receives 30 cubic meters/day of influent with a BOD5 of 350 mg/L that must be reduced to 20 mg/L before discharge.

  How these solutions have improved over time

Discuss some of the impact/ importance of the solutiongenerated and how these solutions have improved over time

  Tape corrections under following conditions

The tape is stretched over three equal spans. Calculate the tape corrections under the following conditions at field, temperature = 85ºF, pull = 18kg, E= 2.109 x 10 6 kg/cm 2

  How much money is equivalent to lump sum with interest rate

how much money today is equivalent to lump sum of $100,000 in 20 years with interest rate of 6% per year compounded (a)monthly, (b)quarterly, (c)semiannually

  Determine the two possible depths offlow

A 200 m wide natural stream, whose cross-section can beapproximated by a rectangular cross-section, contains a dischargeof 80 cumecs. If the specific energy of the flow is 1.5 timesthe minimum specific energy, determine the two possible depths offlow..

  Create a vba function that will return the root of function

Create a VBA function that will return the root of the function e-x -x = 0 using the Newton-Raphson method. The input parameter for the function should be the initial guess for the root. Turn in your code for the VBA function.

  How much energy is stored in an isolated spherical capacitor

How much energy is stored in an isolated spherical capacitor of radius ,R=25 cm, if it is charged to a potential of 5000V?

  Expected boiling-point elevation

What is the expected boiling-point elevation of water for a solution that contains 271 g of sodium chloride dissolved in 1.0 kg of water?

  Determine the magnitudes of the horizontal and vertical

A man having the mass of 77 kg sits in the chair which is pin-connected to the frame BC. If the man is always seated in an upright position, determine the magitudes of the horizontal and vertical reactions of the chair

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd