Determine the maximum fiber stress and the stress in a fiber

Reference no: EM13528832

A simply supported beam, 2 inches wide by 4 inches high and 12 feetlong is subjected to a concentrated load of 2000 lb at a point 3 ftfrom one of the supports. Determine the maximum fiber stress and the stress in a fiber located 0.5 inches from the top of the beamat midspan.

Reference no: EM13528832

Questions Cloud

Estimate the theoretical fracture strength of a brittle : Estimate the theoretical fracture strength of a brittle material ifit is known that fracture occurs by the propagation of anelliptically shaped surface crack of length

Write the following iterated integral as a double integral : Write the following iterated integral as a double integral with aregion R, and use the change of variables to compute the integral:∫x=2x=0∫y=√(2x-x²)y=0√(x²+y²) dy dx

What is the nominal distance in miles between the sw corner : What is the nominal distance in miles between the SW corner ofSec. 2m T 6 S, R 5E, Indiam PM and the NW corner of Sec. 17, T 6 S,R 3 E, Indian PM?

Sketch clearly the velocity and shear stress profiles in : A film of newtonian liquid folws down the outside surface of avertical cylinder of radius R. the flow is steady, laminar and the thickness of the film is constant.

Determine the maximum fiber stress and the stress in a fiber : A simply supported beam, 2 inches wide by 4 inches high and 12 feetlong is subjected to a concentrated load of 2000 lb at a point 3 ftfrom one of the supports. Determine the maximum fiber stress and the stress in a fiber located 0.5 inches from the t..

Compute the elevations at 100-ft stations throughout the : A 800 m vertical curve joins a -3% grade line to a 5% grade line. The PVI of the curve is at station 6200 and its elevation is 600.6 ft. Compute the elevations at 100-ft stations throughout the curve.

Determine the torque needed to turn the impeller : A centrifugal pump is used to pump water from ariver. The absolute velocity V2 = 82ft/s is at an angle of 25 degrees to theradial direction. The impeller's thickness is of 1.2 in and r2= 0.86 ft and rotates at a speed of 1250 rpm.

What is the maximum pressure on the form in psf : What is the maximum pressure on the form in PSF?

If the desired flowrate is at least : Two reservoirs, which differ in surface elevation by 40m, areconnected by 350m of new pipe of diameter 8cm. If the desired flowrate is at least 500N/s of water at 20 degrees C. can the pipematerial be made of

User Account

All Pages