Determine the maximum allowable height h

Assignment Help Civil Engineering
Reference no: EM131152074

Each pylon of the cable stayed bridge has a cable that supports the deck and a backstay. Say the supporting cables carry 70% of the weight of the bridge which weighs 50 Mg. Even though the pylon is built-in at the bottom, the tensions in the backstays are chosen so that the net horizontal force on a pylon due to the two cables is zero. Say the steel pylon consists of two separate box sections, 800 mm x 1000 mm 20 mm thick on the two sides of the deck that join at a certain point above the deck. Let the cables be attached to the pylons at height h, below which the two box sections are separated and equally share the loads of the cables. Determine the maximum allowable height, h, if the box sections are not to buckle in the weaker direction. Take the angles

2468_a76ef62b-40de-48d9-9317-59729fa36d96.png

2307_47f56f7a-15c1-4601-9a6e-b7502b25f42a.png

 

Reference no: EM131152074

Questions Cloud

What is learning organization : What is a “learning organization?” Why is this concept important for today’s organizations?
Is there a breach of contract : Jimmy, an art dealer and merchant, is running out of funds. Luckily, he owns a priceless Van Gogh painting. He writes his friend Tommy. Is there a breach of contract
Problem-solving approach to address : Discuss one (1) project where you used a problem-solving approach to address what turned out to be common-cause variation, or where you used a process improvement approach to deal with a special cause.
Write the essay on the curatorial statement : Write the essay on the curatorial statement.- The initial paragraph should establish the overall premise of the exhibit, the main theme or concept the show.
Determine the maximum allowable height h : Determine the maximum allowable height, h, if the box sections are not to buckle in the weaker direction.
Mass marketing debate : Take a position on whether "mass marketing is dead" vs "mass marketing is still a viable way to build a brand" Provide personal analysis on the position you selected and make some recommendations.
How your corporation could earn above-average returns : Apply the industrial organization model and the resource-based model to determine how your corporation could earn above-average returns
Determining the global marketing challenges : Q1. What global marketing challenges would you face if the simulation were based on a real-world situation? Discuss the difference in the experience you would have with the assumptions built into the simulation (e.g., no cultural barriers, languag..
What is the common-size statement value of inventory : A firm has sales of $1,360, net income of $227, net fixed assets of $469, and current assets of $329. The firm has $95 in inventory. What is the common-size statement value of inventory?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the expressions for attractive and repulsive

Consider some hypothetical X+ - Y - ion pair for which the equilibrium interionic spacing and bonding energy values are 0.38 nm and - 6.38 eV respectively. If it is known that n in the equation has a value of 10, determine the expressions for attract..

  What determines the minimum value of the duration

What determines the minimum value of the duration of the output pulse

  Find the concrete cross-section and steel area required

Find the concrete cross-section and steel area required for a simply supported rectangular beam with a span of 20 ft that is to carry a computed dead load of 1.3 k/ft and a service live load of 2.25 k/ft. Material strengths are fc’ = 5000 psi and fy ..

  Find entropy changes of refrigerant and thermal reservoir

A thermal reservoir (T=308K) is brought in contact with the tank, transferring enough heat to the tank to raise the pressure inside to 4 bar. Calculate the entropy changes of the refrigerant and the thermal reservoir

  Determine downstream depth into gradual contraction section

If the flowrate is Q = 25 ft^3/s and the upstream depth is 2 ft, determine the downstream depth. Sketch the specific energy diagram and indicate its important characteristics. Note that the specific discharges are different.

  Calculate the carbon concentration in steps of 0.2 mm

The decarburization of carbon from a steel with an overall composition Co = 0.3wt% carbon can be expressed by the equation: Cx= Co.erf(z). If the steel is decarburized in vacuum at 1000 C for one hour, calculate the carbon concentration in steps of 0..

  Determine the mass flow rate of the cooling water

refrigerant 134a is compressed at steady state from 2.4 bar, 0 degrees celcius, to 12 bar, 50 degrees celcius. Refrigerant enters the compressor with a volumetric flow rate of 0.38m^3/min, and the power input to the compressor is 2.6 kW.

  Determine what is the probability that the system operates

Consider a system that consists of 4 devices. The probabilities of failure for each of the devices are, respectively: 10%, 25%, 20%, and 30%. (a) If these components were in series, what is the probability that the system operates

  Determine entropy change of air during compression process

Air is compressed from an initial state of 100 kpa and 170 *C to a final state of 600 kpa and 57 *c. Determine the entropy change of air during the compression process by using a) property values from the air table and b) average specific heats

  What is the maximum internal pressure for the maximum stress

If the maximum stress that the tank can sustain equals 22.857 ksi, determine the required thickness (to the nearest 1/4 inch). If the tank wall thickness is specified to be 2.25 inches.what is the maximum internal pressure

  Alsogive the parameter rating in each of the fiveclasses

Giving the classes, explain how rocks are put intofive (5) classes by each of the above parameters. Alsogive the parameter rating in each of the fiveclasses. Hint; use a table to answer this question

  What is differential equation for beams subjected to axial

.An air turbine is used with a generator to generate electricity. Air at the turbine inlet is at 700 kPa and 25 degree C. The turbine discharges air in to the atmosphere at a temperature of 11 degree C.Inlet and outlet air velocities are 100 m/s and ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd