Determine the magnitudes of the velocity v and acceleration

Assignment Help Civil Engineering
Reference no: EM13302127

A particle which moves in two-dimensional motion has coordinates given in inches by x=t^2-4t+20 and y=3sin2t, where the time t is in seconds. Determine the magnitudes of the velocity v and the acceleration a and the angle between these two vectors at time t=3 sec.

Reference no: EM13302127

Questions Cloud

Find the minimum uncertainty in that energy : A cosmic ray interacts for a mere 11fs with its detector. Having just learned about the uncertainty principle, Find the minimum uncertainty in that energy
Determine the corresponding constant rate of acceleration at : If the maximum total acceleration of the train must not exceed 1.5 m/s^2, determine the shortest distance in which the train can reach a speed of 72 km/h, and determine the corresponding constant rate of acceleration at.
Explain what is the peptide sequence : What is the mRNA sequence for the following segment of DNA: GACTATCCCATAGAG Based upon the mRNA sequence, what is the peptide sequence
What wavelength photon would have the same energy : An electron is confined to a box the size of a small atom, 0.12nm across. ?p, What wavelength photon would have the same energy
Determine the magnitudes of the velocity v and acceleration : A particle which moves in two-dimensional motion has coordinates given in inches by x=t^2-4t+20 and y=3sin2t, where the time t is in seconds. Determine the magnitudes of the velocity v and the acceleration a and the angle between these two vectors..
What would you pay for the following bond : What would you pay for the following bond: Coupon 8%, required yield 5% over the risk-free rate, remaining term: 12 years. At present, 12-year T-bills yield 4%.
Does the coo project have a positive or negative npv : Does the COO's project have a positive or negative NPV at the discount rate calculated via the CAPM? Use the following assumptions.
Determine the max and min capacitance of the capacitor : Suppose an RLC circuit must be created by choosing an inductor and capacitor to place in series with a 1200 ohm resistor. To tune in the AM band frequencies, calculate an appropriate value for the inductance and determine the max and min capacitance..
What is the hydrologic risk of occurring in the next 10years : Lake levels have been measured for the past 50 years at Cagles Mill Lake. The highest annual lake levels (in feet, mean sea level) on record are 887.5, 887.3, 886.5, 886.0, 885.9. The other 45 annual peaks are smaller.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine using energy methods speed of crate after moving

The coefficient of friction between the crate and the floor is µs = 0.4 and µk = 0.3. If P is slowly increased until the crate starts to move and then remains constant, determine using energy methods the speed of the crate after moving 2 m.

  Cause of heading-up of the water surface

A rectangular channel 2.0 m wide carrying a discharge of 2.5 m3/s is to be fitted with a weir at its downstream end to provide a means of flow measurement as well as to cause heading-up of the water surface.

  Determine which truck will cause more pavement damage

Truck B has an 8000-lb single axle and a 43,000-lb tandem axle. On a flexible pavement with a 3-inch hot-mix asphalt (HMA) wearing surface, a 6-inch soil-cement base, and an 8-inch crushed stone subbase, which truck will cause more pavement damage

  Magnitude of acceleration-along a circular path

The boat is travelling along a circular path with a speed v=(0.0625t). Determine the magnitude of its acceleration when t=10s

  Find the resultant force from all fluids acting on the gate

a tank is filled with oil (specific gravity 0.8) and water to a depth of 10 meter and 6 meter respectively. Find the resultant force from all fluids acting on the gate of 1.8 meter by 9 meter.

  Calculate the thermal conductivity with the given data

A small house is built in the arctic. It has four square walls of 500 ft2 each. For simplicity, we will assume it has no windows, and we are only interested in calculation the heat loss through the four walls. A total of one hundred Watts (100 kW)..

  Calculate capillary pressure for the inner capillary tube

Two glass capillary tubes of inside diameters of 20 and 13 microns are used to test the capillary rise in an annular cross section .The wall thickness of each capillary is 2 microns .The smaller capillary tube is inserted in the larger one so that..

  Determining the velocity of motor having constant power

A constant power of 1.5 hp is supplied to the motor while it operates with an efficiency of ε = 0.8. Determine the velocity of the 200-lb crate in 15 seconds, starting from rest. Neglect friction.

  Determine the velocity and the acceleration of the particle

the path of particle p ios the elipse difined by relations r=2/(2-cosPIEt) and theta=PIEt, where r is exspressed in meters , tis in seconds nd thet is in radians. Determine the velocity and the acceleration of the particle whern t=0 seconds

  What is the probability that a random sample

What is the probability that a random sample of 20 time intervals between eruptions has a mean longer than 95 minutes?

  Determine entropy change of air during compression process

Air is compressed from an initial state of 100 kpa and 170 *C to a final state of 600 kpa and 57 *c. Determine the entropy change of air during the compression process by using a) property values from the air table and b) average specific heats

  Determine what is the shear strain at the inner surface

a circular steel tube of length L=1.2m is loaded in torsion. If the inner radius of the tube is 45 mm and the measured angle of twist between the ends is 0.4 degrees, what is the shear strain at the inner surface

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd