Determine the magnitude of its acceleration at this instant

Assignment Help Civil Engineering
Reference no: EM13555174

1.The storativity of the Jordan Aquifer (a regional confined aquifer) is 5 x 10-4 and the porosity is 0.3. The thickness of the aquifer is 200 ft.

a)If the head in the Jordan has been pumped down by 100 ft in recent times, how much water in cubic feet has been pumped out of storage for an area of 100 sq. mi.?

2.The two particles A and B start at the origin O and trevel in opposite directions along the circular path at constant speeds va =.7 m/s and vb =1.5 m/s . Determine the time when they collide and the magnitude of the accelerartion of b just before this happens.

3.Car traveling along a circular curve that has a radius of 50m. if its speed is 16m/s and is increasing uniformly at 8 m/s^2 determine the magnitude of its acceleration at this instant.

Reference no: EM13555174

Questions Cloud

What air pressure in psig is needed to raise the maximum : Assume the lubricating fluid is changed to oil with a dynamic viscosity of 1.4X10E-3 lbf-s/ft^2. Now what air pressure, in psig, is required to overcome shear force ? Use the same lift rate of 0.1 ft/sec.
What is the probability that there will be at least one hot : Weather records for a certain region indicate that there is a tendency for two hot summers to occur in a row. From the statistics for the region, the following information has been es tahlished
Derive a formula for the steady rate of descent : This problem involves a cylinder falling inside a pipe that is filled with oil. The small space between the cylinder and the pipe is lubricated with an oil film that has viscosity ?
How can you increase the performance of the least efficient : There are three reactors degrading a chemical biologically, at three degradation rates; i.e., 0.2 d^-1, 0.4 d^-1, and 1.0 d^-1. The residence time of the chemical in these reactors are 10 d, 5 d, and 55 d, respectively
Determine the magnitude of its acceleration at this instant : Car traveling along a circular curve that has a radius of 50m. if its speed is 16m/s and is increasing uniformly at 8 m/s^2 determine the magnitude of its acceleration at this instant.
Determine the maximum water table elevation : A canal was constructed running parallel to a river 1500 ft away. Both fully penetrate a sand aquifer with a hydraulic conductivity of 1.2 ft/d. The area is subject to rainfall of 1.8 ft/y and evaporation of 1.3 ft/y. The elevation of water above the..
What is the discharge rate per unit width of the aquifer to : To avoid the salinization of soil in a farming area, parallel drainage canals are to be installed to maintain the water table at a depth of at least 4m below the ground surface. It is thought that no evapo-transpiration would occur below that depth.
What is the alkalinity of this water expressed as mg/l : A water sample contains 118mg/L of bicarbonate ion, 19mg/L of carbonate ion, and has a pH of 9.5. What is the alkalinity of this water expressed as mg/L of CaCO3?
What is a chance that a driver who has a positive breathalyz : A police officer stops a speeding driver on saturday nigt and gives hima breathalzer test. the test shows that his estimated blood alcohol content is above .08 g/dl, and this is considered evidence of driving while intoxicated

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what would the deflection be at the right end

A 2-inch by 2-inch solid steel beam (18 inches long) is fixed to the wall at the left to resist applied moment (20,000 lbs-inch). What would the deflection be at the right end Up or down

  How to compute the saturated unit weight of the silt

All the silt is saturated even after the water table is lowered. (In this problem, treat the unit weight above the water table as bulk unit weight and the unit weight below the water table as saturated unit weight.)

  Velocity profile from the pipe wall

Compute points on the velocity profile from the pipe wall to the centerline of a 3/4-in Type K copper tube if the volume flow rate of water at 60 degrees F is .50 gal/min.

  Give the phase and the missing property of

Give the phase and the missing property of P, T, v and x. Put the values in a table withcolumns P, T, v, and x.

  Define need before function

Which of the following is not a basic systems engineering concept?a. Define need before function

  Determine the dimension of this proposed footing

A proposed square footing carrying a total load of 900 kips is to be constructed on a uniform thick deposit of cohesionless soil. The soil's unit weight is 135 pcf, and its angle of internal friction is 38 degrees.

  All losses except for the flow control valve are negligible

The fountain shown is designed to provide a stream of water that rises h=10ft to h=20 ft above the nozzle exit in a periodic fashion. To do this the water from the pool enters a pimp

  Determine the equivalent uniform annual cost

Art Arfons, a K-State-educated engineer, has made a considerable fortune. He wishes to start a perpetual scholarship for engineering students at K-State.

  Explain what processes are required to be put into place

The business it to make dinner ware for various markets this will include plastic utensils (forks, knives, spoon, etc) as well as low end flat ware suitable for institutions such as high school college cafeterias.

  Estimate the first derivative of f

Write a script newquot.m that uses the Newton quotient, [f (x + h) - f (x)]/h, to estimate the first derivative of f (x) = x3 at x = 1, using successively smaller values of h: 1, 10-1, 10-2, and so forth. Use a function M-file for f (x).

  Specify the hydraulic retention time for a pfr designed

In each experimental run, the concen tration of free available chlorine was varied and the time required to kill 99% of the organisms was determined. The results showed that a CT value of 200 min mg/L was sufficient to achieve a 2-log removal.

  Find flow rate and the pressure head at the base of nozzle

The entrance to the pipe is reentrant, with ke = 0.9, and the nozzle loss coefficient is 0.045. Find the flow rate and the pressure head at the base of (entrance to) the nozzle.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd