Determine the liquid limit

Assignment Help Civil Engineering
Reference no: EM13555156

The following data were recorded from a liquid limit test on a clay using the Casagrande cup device.

Test # Container (g) Container & wet soil (g) Container & dry soil (g) Blow count

Weigh container Weight of wet soil Weight of dry soil N

1 45.3 57.1 54.4 28

2 43.0 59.8 56.0 31

3 45.2 61.7 57.9 22

4 45.6 58.4 55.3 18

Determine the liquid limit

Reference no: EM13555156

Questions Cloud

What fraction of the flue gas stream would need to be bypass : An electrostatic precipitator for a coal-fired power plant has an overall particulate recovery of 95%. The company engineer decides that this is too good, that it is not necessary to be this efficient
What is the pressure difference measured by the manometer : The "U"-tube manometer containing mercury of density 13600 kg/cubic meters is used to measure the pressure drop along a horizontal pipe.
What tensile force should be applied to the bar to maintain : Suppose that in an apparatus it is necessary to maintain precisely the cross section of a 20mm circular nickel steel bar. If this bar is heated to 200 deg Celcius
A cast brass rod 60mm in diameter and 150mm long is compress : A cast brass rod 60mm in diameter and 150mm long is compressed axially by a uniformly distributed force of 200kN. Determine the increase in diameter caused by the applied force, E=85GPa; poisson's rato=.30
Determine the liquid limit : The following data were recorded from a liquid limit test on a clay using the Casagrande cup device.
Is this soil a food foundation material : The results of a particle size analysis of a soil are given in the following table. No atterberg limit test were conducted.
Determine the liquid limit of this clay : The following results were obtained from a liquid limit test on a clay using the Casagrande cup device.
Determine lengths l1 and l2 so the two materials elongate : A solid cylinder of 50 mm diameter and 900 mm length is subjected to a tensile force of 120kN. One part f the cylinder L1 long is of steel, the other part
What is the percentage error in the bulk unit weight : What is the percentage error in the bulk unit weight if the soil is the percentage error in the bulk unit weight if the soil is 95% saturated but assumed to be 100% saturated?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find length of pipe needed to bring water to saturated vapor

Saturated liquid water at 1000 kPa flows at 2 kg/s inside a 10 cm outer diameter steel pipe and outside of the pipe is a flow of hot gases at 1000 K with a convection coefficient of h = 150 W/m2 K.

  Determine what will be the discharge through the pipe

A pump having the characteristics given( N=2133.5 rpm, n=35.6 rps, D=37.1 cm) pumps water at 25 degree C from a reservoir at an elevation of 366 m to a reservoir at an elevation of 450 m through a 36 cm steel pipe.

  Determine the source and sink temperature

Carnot engine working between a source temperature of T2 and sink temperature of T1 has efficiency of 25%. if the sink temperature is reduced by 20 degrees Celsius the efficiency is increased to 30%. find the source and sink temperature

  At what rate is the diameter increasing

a spherical balloon is being inflated so that its volume is increasing at the rate of 5 cu meter/min. at what rate is the diameter increasing when the diameter is 12m?

  Estimate the power in watts that can be produced by turbine

The design wind speed is 15 mph at T=10C and p=0.9 bar. The efficiency of the turbine is n=20% meaning that 20% of the kinetic energy in the wind can be extracted. estimate the power in watts that can be produced by the turbine.

  Determine the mean effective pressure of an ideal otto cycle

At the beginning of compression the pressure is 14 psi and the temperature if 60°F. The temperature at the end of combustion heat addition is 1500°F and the compression ratio is 9. Use constant specific heats at room temperature

  What is the so2 concentration at a sampling point located

If the effective stack height of the plant is 100 m, and the ground reflects the SO2 emission perfectly what is the SO2 concentration at a sampling point located 2 m above the ground in the town.

  Shafts in a speed-reducer unit

The two shafts in a speed-reducer unit are subjected to couples of magnitude M1 = 18 N · m and M2 = 7.5 N · m, respectively.

  What would the mean and variance of cx be in terms of e

If the mean and variance of discrete random uniform random variable X, are E(X) and V(X) respectively, what would the mean and variance of cX be in terms of E(X) and V(X) if c is a constant

  Determine what is the doubling time in units of days

A pig farmer owns a 20-arce farm and started business with 22.1 pigs. After one year, he has 319 pigs. Assuming a constant growth rate, what is the doubling time in units of days.

  What is the added mass on the roof

The Hubert H. Humphrey Metrodome in Minneapolis opened in 1982 at a cost of $55 million. To prepare for the footings, et cetera, 30.0x10^5 cubic yards of dirt were removed.

  Determine what force must apply at the ends to achieve

What couple moment does he exert. How much could he exert if he moved his hands to the ends so that his hands are 254 inches apart. What force must he apply at the ends to achieve the same couple moments as when he held his hands 18 inches apart.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd