Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A positive-sequence balanced three-phase wye-connected source witha phase voltage of 120 V rms supplies power to a balanced wye-connected load. The per phase load impedence is 40 + 10JΩ. Determine the line current in the circuit if the angle Van=0 degrees.
A charge q is located at each corner of an equilateral triangle of side a. Find the magnitude of the force on each charge. Sketch the directions of forces.
A signal source produces a 4 volt peak-to-peak sinusoid and has a source resistance of 100 ohms. We wish to drive a grounded 10 ohm load to at least 2 volts peak-to-peak with this source. The load cannot tolerate DC. Your amplifier should not burn..
What assumptions would need to be satisfied for the implementation of Bayes Classifier, Euclidean, Mahalanobis, Parzen windows, Gaussian probability density function, Maximum likelihood parameters estimation of Gaussian pdfs, Naïve Bayes, Guassian..
The charge entering the positive terminal of an element is q = 10 sin 4 piet mC while the voltage across the element (plus to minus) is v = 2 cos 4 pie t V. (a) Find the power delivered to the element at t = 0.3 s.
A natural gas power plant has a condenser that extracts 28,000 Btu/kg of natural gas. Compute the mechanical energy of the turbine and the overall system efficiency
A negative unity feedback loop with input R(s), output Y(s) and error E(s) is placed around the system \(H(s)=1/((s+p_{1})(s+p_{2})...(s+p_{q}))\)(a) Find the transfer function E(s)/R(s).
design a conditiong circuit that takes an input from a temp sensor and coverts it to a voltage. The input is a function of temp and the output changes with temp. The op-amp is fine but I dont understand how to incorporate the temperature into this..
A system has a powe gain of 52. Directivity is measured as 90 and the dissipated power in an antenna with a gain of 700 is 1.9 watts. what is the EIRP in watts and dBm
suppose that in the fluid-low analogy for an electrical circuit analog of electrical currentis volumetric flow rate with units of cm^3/s. For a proper analogy to electrical ciruits, must the fluid be compressible or incompressible
In a long cilindric wire with a radius of 2 cm, a corrent with 80A goes thorugh it. What is the magnetic energy per unit of wire lenght?
a single phase transformer has the following ratings: 10kVA,240/2400V. In the open circuit test with rated primary voltage(240V), the primary current is 0.85A and secondary voltage is2400V. A short circuit test is performed as follows
a sound distribution system has the following outputs 10 watts at 8ohms,5watts at 4 ohms, 15 watts at 16 ohms and 2 watts at 4 ohms if the input to the amplifier is 20 millivolts at 600 ohms how much gain in decibels will be required of the amplif..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd