Determine the length of the rough spot

Assignment Help Physics

Reference no: EM13249123

A mass m = 14 kg rests on a frictionless table and accelerated by a spring with spring constant k = 5209 N/m. The floor is frictionless except for a rough patch. For this rough path, the coefficient of friction is Î¼k = 0.46. The mass leaves the spring at a speed v = 4 m/s.

1) How far was the spring stretched from its unstreched length?

2) The mass is measured to leave the rough spot with a final speed vf = 1.8 m/s. How much work is done by friction as the mass crosses the rough spot?

3) What is the length of the rough spot?

4) In a new scenario, the block only makes it (exactly) half-way through the rough spot. How far was the spring compressed from its unstretched length?

5) In this new scenario, what would the coefficient of friction of the rough patch need to be changed to in order for the block to just barely make it through the rough patch?

6) Return to a scenario where the blcok makes it throgh the entire rough patch. If the rough patch is lengthened to a distance of three times longer, as the block slides through the entire distance of the rough patch, the magnitude of the work done by the force of friction is:

A) The same.

B) Three times greater.

C) Three times less.

D) Nine times greater.

E) Nine times less.

Reference no: EM13249123

Questions Cloud

Determine the average power dissipated in re in watts : For the circuit following parameters are given with Vcc = 18 volts DC: Rs = 0 ohm r pi = 1000 ohm Rb = 1750 ohms C1 = 10 microfarads gm = 50mS RL = 100 ohms Ce = 0.1 microfarads Re = 135 ohms C2 may be considered very large

What is the taguchi quality cost of that sample of 5 cupcake : You take a sample of 5 cupcakes, and the diameters are 37.8, 37.7, 38.1, 38.6, and 38.0 mm.

Define the changes in its volume when the pressure undergoes : A gas pressure of 2.0 atm is in a closed container. Indicate the changes in its volume when the pressure undergoes the following changes at constant temperature: a) the pressure increases to 6.0 atm. b) the pressure drops to 1.0 atm. c) the pressu..

Discuss which concepts are the most important to consider : Discuss which concepts are the most important to consider when designing information security policies and procedures.

Determine the length of the rough spot : A mass m = 14 kg rests on a frictionless table and accelerated by a spring with spring constant k = 5209 N/m. The floor is frictionless except for a rough patch, What is the length of the rough spot

State the trends in melting points going from the chloride : explain the trends in melting points in going from the chloride to the flouride, making direct reference to the attractive forces that must be overcome to melt the solid and why their strength varies.

Distinguish between a minimization and maximization lp model : Distinguish between a minimization and maximization LP model. How do you know which of these to use for any given problem?

What are some business uses of a linear programming model : what are some business uses of a linear programming model? Provide an example.

Explain why the melting points of sodium halides very high : Why are the melting points of sodium halides very high and the melting points of silicon halides very low. Response should include descriptions of the bonding and refernce to the attractive forces that must be overcome in the two types of compound..

User Account

All Pages