Determine the largest allowable vertical shear in the beam

Assignment Help Civil Engineering
Reference no: EM13313574

The composite beam shown is fabricated by connecing two W6 x 20 rolled-steel members, using bolts of 5/8 in. diameter spaced longitunally every 6 in. Knowing that the average allowable shearing stress in the bolts is 10.5 ksi, determine the largest allowable vertical shear in the beam.

Reference no: EM13313574

Questions Cloud

The autonomic nervous system : A person with a fear of heights drives across a high bridge. which structure will stimulate a response from the autonomic nervous system?
Explain what volume will the nitrogen gas occupy : Liquid nitrogen has a density of 0.808 g/mL at 77 K. A sample of 1.5 L of liquid nitrogen is allowed to evaporate at 22.2 °C and 0.998 atm of pressure. What volume will the nitrogen gas occupy
What is annual inflation rate and is it compounded annually : A newspaper reports that in the last 5 years, prices have increased a total of 50%. this is equivalent to what annual inflation rate, and is it compounded annually
Explain how many gas molecules are present : A 498 mL sample of laughing gas, N2O, is at 30 oC and 414 torr pressure. (a) How many gas molecules are present? (b) How many atoms are there
Determine the largest allowable vertical shear in the beam : diameter spaced longitunally every 6 in. Knowing that the average allowable shearing stress in the bolts is 10.5 ksi, determine the largest allowable vertical shear in the beam.
How much heat is produced by the complete rection : Nitromethane CH3NO2) burns in air to produce significant amounts of heat. How much heat is produced by the complete rection of 6.66kg of Nitromethane
What mass of microbes will be produced in the pond each day : A perfectly mixed aeration pond with no recycle serves as the biological reactor for a small community. The pond receives 30m^3/d of influent with a BOD5 of 350mg/L that must be reduced to 20mg/L before discharge.
Explain a sample of diatomic gas has a density : A sample of diatomic gas has a density of 0.002061 g/mL at 1.8 atm pressure and 25.0 °C. Identify the gas.
Describes the genders of two children : Describes the genders of two children

Reviews

Write a Review

Civil Engineering Questions & Answers

  How many tons of asphalt concrete will be require to overlay

How many tons of asphalt concrete will be required to overlay a 3-mile-long, 24-ft.-wide road with 2.5 in. of wearing course asphalt concrete that has a density of 146.3 pcf

  How much can be afford to spend for a car averaging

How much (in addition to your trade-in value) can you afford to spend for a car averaging 30 mpg You expect to drive 15,000 mile/year and expect gasoline to cost $4.00/gallon and you will keep he car 10 years. Your personal interest rate is 6%/yea..

  Is the state water-quality standard being met downstream

If the state standard downstream is not met, the state has informed town 1 that it must treat its sewage further so the downstream standard is met. Use a mass balance approach to show that the state's request is unfeasible.

  Determine the head loss for the clean filter bed

The rapid sand filter being designed for Laramie has the characteristics show below. Determine the head loss for the clean filter bed in a stratified condition. Depth = 0.75 m

  Find summer values for oxygen demand and oxygen tranfer

A fine-bubble aeration basin has a flow of 21.5 mgd, an influent BOD of 180 mg/l, 31 mg/l of mmonia, and effluent of 10 mg/l. During the winter, the wastewater temperature of 14.8 degrees C does not nitrify.

  Determine the velocity and acceleration of point b

The velocity of the center point of the wheel is constant at 20 ft/sec to the right. For the instant, determine the following: a) The velocity and acceleration of point B (which is attached to the wheel) measured with respect to ground.

  Draw the influence line for the support reaction

Draw the influence line for the support reaction at A and calculate the support reaction at point

  Determine the maximum acceleration of the camera

The vertical velocity of the box at the time that it hits the surface is v= 5m/s. After impact the camera experiences an acceleration of a = -kx, where k is a constant and x is the compression of the packing material.

  What is the aftertax cash flow from the sale of the asset

Consider an asset that costs $712,000 and is depreciated straight-line to zero over its eight-year tax life. The asset is to be used in a five-year project; at the end of the project, the asset can be sold for $184,000

  Load that a boat can carry without sinking in a lake

The hull of a boat has a volme of 150m and the total mass of the boat when empty is 8560kg. determine how much load this boat can carry without sinking in a lake.

  How much larger should street name be in order to be legible

street nam sizes on the signs at a certain location can be discerned by a person with 20/40 vision from a distance of 300 ft. how much larger should the street names be in order to be legible to a person with 20/50 vision from a distnace of 450 ..

  Perform a check that the elevation of the curve at station

A vertical curve is to connect two tangents that intersect at station 30+50 at an elevation of 800.00 ft. The approach gradient is 3 percent and the departure gradient is -5 percent. The elevation of the curve at station 32+50 must be equal to at ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd