Determine the initial weight and final density of the water

Assignment Help Civil Engineering
Reference no: EM13303296

A steel tank hold 120 ft^3 of water at atmospheric pressure(14.7psi and 68.4 degrees f). the water is subjected to a 100 fold increase in pressure. determine the initial weight and final density of the water if the volume decreases by .545 ft ^3.

Reference no: EM13303296

Questions Cloud

Pay the loan back using simple amortization : You have the chance to expand your business by making an investment (Initial Investment) that requires 'n' years to finish (Completion date after start ), after which a fixed rate of return (Rate of return after completion) of 'X %/yr' will be return..
Describing a policy issue of interest : Policy Analysis Paper: The paper requires two submissions. The first, a proposal, is a very short document (no more than two pages), describing a policy issue of interest to you currently under consideration by the federal, state, or local government..
Determine the bulk modulus of elasticity of a liquid : Determine the bulk modulus of elasticity (in N/m^2) of a liquid that has a 1.10 percent volume decrease because of an increase in pressure from 1,000 N / cm^2 to 11,000 N / cm^2.
Find is the cyclist ahead of or behind the car : At rest, a car's horn sounds the note A (440 Hz). The horn is sounded while the car is moving down the street. find Is the cyclist ahead of or behind the car
Determine the initial weight and final density of the water : A steel tank hold 120 ft^3 of water at atmospheric pressure(14.7psi and 68.4 degrees f). the water is subjected to a 100 fold increase in pressure. determine the initial weight and final density of the water if the volume decreases by .545 ft ^3.
Determine the minimum length of curve that can be designed : you are designing a highway to AASHTO guidelines on rolling terrain where the design speed will be 65 mi/hr. At one section, a +1.25% grade and a -2.25% grade must be connected with and equal tangent vertical curve.
Calculate the intensity of the sound wave emitted : The toadfish makes use of resonance in a closed tube to produce very loud sounds. The tube is its swim bladder, used as an amplifier. Calculate the intensity of the sound wave emitted
Determine what will current be and what will the power be : suppose we have a 100-volt battery connected with a 100-ohm resistance. The current is then 100/100=1 amp. how much power is produced. if we double the voltage, what will the current be and what will the power be.
What is the half-life of this radioactive material : 25% of a radioactive material stays active after 4 hours. What is the half-life of this radioactive material

Reviews

Write a Review

Civil Engineering Questions & Answers

  Compute nominal and effective annual interest rate

A bank is offering to sell 6-month certificates of deposit for $9800. At the end of 6 months, the bank will pay $10,000 to the certificate owner. Compute the nominal annual interest rate and the effective annual interest rate

  Determine is the flow rate typical for a bathroom faucet

Water in a household plumbing system originates at the neighborhood water main where the pressure is 480kPa, the velocity is 5m/s, and the elevation is 2.44 m. A 19 mm (3/4-in) copper service line supplies water to a two-story residence

  What is the elevation of the tip of the spire

The telescope of the instrument is 5.25 ft above the ground station, whose elevation is 415.65 ft. What is the elevation of the tip of the spire? (Ignore atmospheric refraction and earth curvature)

  Estimate critical pressure of mixture of methane nd n-hexane

Estimate the critical pressure of a mixture of methane and n-hexane if the critical temperature of the mixture is known to be 200 F. Compare your answer with the critical pressures of pure methane and pure n-hexane.

  Spreader beam and hoisted by a crane

The 3.5mg engine is suspended from a 500 kg spreader beam and hoisted by a crane which gives it an acceleration of 4m/s^2 when it has a velocity of 2m/s. determine the force in chains AC and AD during the lift.

  Determine ft and fn

for this purpose replace this force by its equivalent of two forces at At Ft parallel and Fn perpendicular to the beam. Determine Ft and Fn.

  Design the roof slab as a one-way slab system

Design the roof slab as a one-way slab system and use the worst case design scenario to determine the reinforcing for the entire roof

  What is the maximum safe speed around the curve

What is the maximum safe speed around the curve? If the speed limit on the roadway is 60mph, what action should be taken by the engineer?

  Calculate the density and specific weight of carbon dioxide

calculate the density and specific weight of carbon dioxide at a pressure of 300 kN/m^2 absolute and 60º C

  Total energy per unit weight of fluid

A fluid flowing in a pipe 30cm in diameter has a uniform velocity of 4m/s. The pressure at the center of the pipe is 40KPa, and the elevation of the pipe's centerline above an assumed datum is 4.5m. Compute the total energy per unit weight of the ..

  What is the stationing of the pt on the same highway

A crest vertical vurve and a horizontal curve on the same highway have the same design speed. The equal-tangent vertical curve connects a +3% initial grade with a +1% final grade and has a PVC at 101+78 and a PVT at 106+72

  What is the average annual inflation rate for the machine

You purchased a machine 5 years ago for $100,000 and now the machine costs $135,000. What is the average annual inflation rate for this machine

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd