Determine the induced internal voltage and torque angle

Assignment Help Electrical Engineering
Reference no: EM13253776

A 480V, 60Hz, Y-connected 2 pole synchronous generator has internal parameters of Armature Resistance 0.05ohms, Synchronous Reactance 0.5ohms. The input power to the geenrator is 100hp. When the generator is operating at rated values and unity power factor, the generator is 80% efficient.

a.) Find the generator speed in rpm and rad/sec.

b.) Find the mechanical torque supplied to the generator.

c.) Find the output power in watts and horsepower.

d.) Find the output current.

e.) Determine the induced internal voltage and torque angle.

f.) Find the electric losses.

g.) Find the constant losses in the generator.

h.) If the output power remains constant and the power factor changes to 0.8 leading, find the new required input power in watts and horsepower.

Reference no: EM13253776

Questions Cloud

Are the specifications being met : specifications for the computer upgrades in problem 4 are 78 minutes and 81 minutes. based on the date given in the problem, are the specifications being met?
Summarize the alleged violation : Include a minimum of three sources, which may consist of readings from the University Library, your text,other selections, and your own experiences.
Find the input power to the generator in horsepower nd watts : A 500-kVA, 60Hz, 5000V, Y-connected, 10 pole synchronous has internal parameters of Armature Resistance 1ohm amd Synchronous Reactance 10ohms. The generator is operating at rated values and 0.9 pf leading.
What is the total charge on the solid cylinder : A solid insulating cylinder of radius A is surrounded by a hollow, concentric conducting cylinder of inner radius A and outer radius B. What is the total charge on the solid cylinder
Determine the induced internal voltage and torque angle : The input power to the geenrator is 100hp. When the generator is operating at rated values and unity power factor, the generator is 80% efficient. a.) Find the generator speed in rpm and rad/sec. b.) Find the mechanical torque supplied to the gener..
What is the maximum possible power that generator can supply : A three-phase, 5kVA, 208 V, four-pole, 60Hz, Y-connected synchronous generator has negligible stator winding resistance and a synchronous reactance of 8 ohms per phase at rated terminal voltage.
Find the number of poles in the machine and generator : A three phase motor is connected to a 60Hz electrical source. The motor spins at 600rpm. Find the number of poles in the machine. The output of the above motor is connected to the input of a generator.
Statement of problem or problems facing the firm : Statement of problem or problems facing the firm. State the problem(s) clearly andsuccinctly. Explain why you believe it (or they) is important.
Explain what is the internal energy change : The enthalpy change for the reaction below at 25oC is -1,850 kJ (per mole of C9H20). What is the internal energy change for the reaction at 25oC

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine reactive power required from a parallel capacitor

A 1 load draws 6 MW at 0.8 power factor lagging. Determine the reactive power required from a parallel capacitor to bring the power factor of the parallel combination up to 0.93

  What should thevenin equivalent resistance of power amplier

Suppose you are designing a power amplifier for a loudspeaker which has an equivalent resistance of 150 . What should be the Thevenin equivalent resistance of the power amplifier in order to maximize the power transfer to the loudspeaker

  Calculate the unit length capacitance of the cable

The cylindrical coaxial cable with the cross section shown below, has inner and outer radii of 5mm and 15mm respectively. The dielectric parameters are; er=2, signma=5*10^(-10) S/m and Ur=1.

  Determine values of resistance-r and capacitance-c

A resistor R, capacitor C, and voltage source Vs= 100 cos 300t Vare all in series. If the average power dissipated by the resistor is 150 W and the rms capacitor voltage is $) V, determine R and C.

  Compute the image frequency and its db of suppression

An AM broadcast receiver's pre-selector has a total effective Q of 90 to a received signal at 1180 kHz and uses an IF of 455 kHz. Calculate the image frequency and its dB of suppression.

  Determine the sending end voltage and current

A three-phase transmission line is 80 mile long and serves a load of 250 MW at 220 KV and 0.8 power factor lagging. The A, B, C, D constants for the line in each phase are: Determine the sending end voltage and current

  Compare and contrast transmit and receive diversity

Compare and contrast transmit and receive diversity. Describe how each diversity type lead to an improvement in system performance.

  How many bytes of data can we store in the memory

If we use the PC-relative addressing mode, and want to allow control transfer between instructions up to 50 locations away, how many bits of a branch instruction are needed to specify the PC-relative offset

  How is the problem-solving process different

How is the problem-solving process different when programming in assembly language versus programming in ladder logic?

  Define why an instrumentation amplifier one stage

Explain why an instrumentation amplifier has more than one stage? How would you increase the output current of an op-amp?

  Explain what is the input impedance

If we have a 600ohm transmission line terminated with a 1200ohm resistor, how long must the transmission line be if the input impedance is purely real?

  Solve communications systems

Give a different equation, in terms of the input and output, to describe the system. Is the system stable?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd