Determine the indicated property-ammonia- water-refrigerant

Assignment Help Mechanical Engineering
Reference no: EM13718095

Using the appropriate table, determine the indicated property. In each case, locate the state on sketches of the T-v and T-s diagrams. Include the vapor dome on the diagram. (a) Water at p = 0.20 bar, s = 4.3703 kJ/kg.K. Find h, in kJ/kg. (b) water at p = 10 bar, u = 3124.4 kJ/kg. Find s, in kJ/kg.K. (c) Refrigerant 134a at T = -28oC, x = 0.8. Find s, in kJ/kg.K. (d) Ammonia at T = 20oC, s = 5.0849 kJ/kg.K. Find u, in kJ/kg.

Reference no: EM13718095

Questions Cloud

How many grams of nh4no3 are needed to produce : How many liters of water vapor are produced when 26.1g of NH4NO3 decomposes and how many grams of NH4NO3 are needed to produce 18.0L of oxygen?
Calculate the flow rate of water required : What is the water exit temperature under these new conditions, and by how much is the heat-transfer rate reduced?
Determine the change in specific entropy : Using the appropriate table, determine the change in specific entropy between the two specified states, in Btu/lb.oR. Show the states on a sketch of the T-s diagram. Include the vapor dome where appropriate.
The vapor pressure of water : When solid CaCO3 is heated, it decomposes to give solid CaO and CO2 gas. A volume of 285mL of gas is collected over water at a total pressure of 730mmHg and 16 °C. The vapor pressure of water at 16 °C is 14 mmHg. CaCO3(s)→CaO(s)+CO2(g)
Determine the indicated property-ammonia- water-refrigerant : Using the appropriate table, determine the indicated property. In each case, locate the state on sketches of the T-v and T-s diagrams. Include the vapor dome on the diagram. (a) Water at p = 0.20 bar, s = 4.3703 kJ/kg.K. Find h, in kJ/kg. (b) water a..
Discuss the conditions for formation the oxide and carbide : In the preparation of He, CH4 is removed but the gas composition contains a variation of CO and CO2 content. The He-CO-CO2 gas leaves the reactor at 1400 K through a nichrome alloy duct. The nichrome originally containing approximately 28-mol% Cr fai..
Determine the molar mass : Determine the molar mass of each of the following gases: 0.93g of a gas that occupies 410mL at 0 °C and 1.00 atm (STP). 1.26g of a gas that occupies 1.00L at 0 °C and 760 mmHg (STP). 1.54g of a gas that occupies 1.40L at 680mmHg and 22.0°C. 3.0g of a..
Constant temperature : A tank of oxygen holds 14.0L of oxygen (O2) at a pressure of 30.0atm . When the gas is released, it provides 230.L of oxygen. What is the pressure of this same gas at a volume of 230.L and constant temperature?
What would the pros and cons be of using each technique : Provide a definition, in your own terms, of frequently used logistics techniques and give an example of a real company or industry that uses this logistics technique.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The temperature is 68 f and the velocity is 40 fts the exit

a pump steadily draws water at a mass flow rate of 20 lbms through a piping arrangement. the pressure at the inlet is

  Heat pump cycle delivers energy by heat transfer to dwelling

A Heat pump cycle delivers energy by heat transfer to a dwelling at a rate of 40,000 Btu/h.The coefficient of performance of the cycle is 2.8. Determine the power input to the cycle, in hp.

  At intel 000005 of manufactured chips have defects in a

at intel 0.00005 of manufactured chips have defects. in a day 5 million chips are produced. what is the probability

  Mechanical power that is converted to thermal energy

Water is pumped from a lower reservoir to a higher reservoir by a pump that provides 23kW of shaft power. The free surface of the upper reservoir is 46m higher than that of the lower reservoir. If the flow rater of water is measured to be 0.03m^3/s d..

  Determine a the final temperature of the steam in the tank

118 an insulated rigid tank whose volume is 0.5 m3 is connected by a valve to a large vessel holding steam at 40 bar

  Satisfy the continuity equation

Consider an incompressible 2D velocity field where u =-2xy and y = x^2-y^2 in Cartesian coordinates. Is it a valid 2D flow (satisfy the continuity equation)?

  If the mercury level in the manometer is higher on the side

a mercury manometer ?13600 kgm3 is connected to an air duct to measure the pressure inside. the difference in the

  If viscous affects are negligible determine the diameter dz

water flows upward through a variable area pipe with a constant flowrate q dz is the diameter of the variable area pipe

  What are the sources of error in your system how can you

design an experiment complete with instrumentation to determine the specific heats of a liquid using a resistance

  Force and its location on the cork due to saltwater

A small, narrow, flat-bottomed fishing boat is loaded down with two crew member and a catch fish. The rear of the boat is a plane inclined at an angle θ of 75 degrees with the horizontal. Thirty centimetres below the water surface is a hole in the b..

  Determine the pressure inside the cylinder

If the atmospheric pressure is 90 kPa, determine the pressure inside the cylinder.

  2-lbm of water at 300 psia fill a weighted piston-cylinder

2-lbm of water at 300 psia fill a weighted piston-cylinder device whose volume is 2.5 ft3. the water is then heated at

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd