Determine the horizontal force p that must be applied

Assignment Help Civil Engineering

Reference no: EM13552915

1.The wedge is used to level the member. Determine the horizontal force P that must be applied to move the wedge to the right. The coefficient of static friction between the wedgeand the two surfaces of contact is ?s=.25. Neglect the size and weight of the wedge.

2.Compute the energy loss in a 90 degree bend in a steel tube used for a fluid power system. The tube has a 0.5 inch outside diameter and a wall thickness of 0.065 inches. The mean bend radius is 2.00 in. The flow rate of hydraulic oil is 3.5 gal/min.

Reference no: EM13552915

Questions Cloud

Find the hydraulic conductivity of the aquifer : A confined aquifer 30 m thick has been pumped from a fully penetrating well at a steady rate of 5000 m3/day for a long time. Drawdown at an observation well 15 m from the pumped well is 3.0 m

Who else was there at the time and how they might have : Develop a timeline up to 1900 with considerable expansion of Henry Martyn Leland's work at The Springfield Armory, Colt, Brown & Sharpe, and L & F (in Detroit)

What do will result if the concentration of the waste : The discharge from the Renenutet sugar beet plant causes the DO at the critical point to fall to 4.0 mg/L. The Meskhenet Stream has a negligible BOD and the initial deficit after the river and wastewater have mixed is zero

Find the standard deviation of the clearance : It is possible to adjust the mean hole diameter. To what value should it be adjusted so as to maximize the probability that the clearance will be between 0.05 and 0.09 cm?

Determine the horizontal force p that must be applied : The wedge is used to level the member. Determine thehorizontal force P that must be applied to move the wedge to theright. The coefficient of static friction between the wedgeand the two surfaces of contact is

V is the shear force at the same point : Follow the derivation of the following equations for deflections of a beam, filling in all the required assumptions and steps in the derivations.EIv'' = M EIv''' =V EIv'''' = ? q where v is the deflection of the beam, E is Young's modulus

Derive an expression for small flow rates over a spillway : Derive an expression for small flow rates over a spillway, in the form of a function including dimensionless quantities. Use dimensional analysis with the following parameters

Determine on a per unit mass of air flowing : An ideal Brayton refrigeration cycle has a compressor ratio of 3.75. The air enters the compressor at 1bar, 27°C. The temperature at the inlet of the turbine is 77°C. Using Air Standard Method Determine on a per unit mass of air flowing

Determine the magnitude of p : A 50-kg crate is pulled by the constant force P at an angle of 30 deg off the x axis- the crate starts from rest and achieves a speed of 10 m/s in 5 s. the coefficient of kinetic friction between the crate and ground is 0.2. Determine the magnitude o..

User Account

All Pages