Determine the frequency of the second and third poles

Assignment Help Electrical Engineering
Reference no: EM131207061

A three-stage 741 op-amp has a low-frequency open-loop gain of 200,000 and a dominant pole frequency of 10 Hz. The second and third poles are at the same frequency. If the phase margin is 70 degrees, determine the frequency of the second and third poles.

Reference no: EM131207061

Questions Cloud

Two products and uses conventional costing system : Kunkel Company makes two products and uses a conventional costing system in which a single plantwide predetermined overhead rate is computed based on direct labor-hours. Using the company's conventional costing system, compute the unit product costs ..
Problem regarding the performance management : Imagine you are an employee of an investment firm where you have been working hard all year, hoping to be rewarded at your annual review.
Write the analytical expression for the waveforms : Write the analytical expression for the waveforms of given figure with the phase angle in degrees.
Determining the emergency management agency : You work as an emergency manager for a small town that just created the position. As the local emergency management agency did not previously exist you are in charge of a new agency.
Determine the frequency of the second and third poles : A three-stage 741 op-amp has a low-frequency open-loop gain of 200,000 and a dominant pole frequency of 10 Hz. The second and third poles are at the same frequency. If the phase margin is 70 degrees, determine the frequency of the second and third..
Common to gift tax formula and estate tax formula : Identify the features common to the gift tax formula and the estate tax formula. As Congress readies to enact the estate tax at 55%, do you think this is good or bad for the economy? For the society? For families?
Conservative and liberal actors : Race relations have once again become a debated political topic. Within the public dialogue, conservative and liberal actors have made competing claims regarding the causes of contemporary racial conflict.
Write the analytical expression for the waveforms : Repeat given problem for the waveforms of given figure.- Write the analytical expression for the waveforms of given figure with the phase angle in degrees.
What is the dominant pole frequency : The feedback capacitor is across the second stage, which has a gain of -103. The effective resistance at the input of the second stage is Req = 1.2 M. What is the value of the feedback capacitor?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Design a schmitt trigger circuit that has a window of 5v

Use rail voltages of +/-15V. Sketch the circuit diagram and the voltage transfer characteristic (Vout vs Vin) Discuss how you chose the values of the components and comment on how accurately you think you can achieve the specification.

  Find what is probability that given ground state is occupied

The donor ground states for tellurium in GaAs are 5.9 meV below conduction band (there are 2 of them because of spin). Atroom temperature (300 K), what is probability that a given ground state is occupied if the Fermi level (Ef) is 0.1 eV below Ec

  Determine which output signal suers the worst delay

If Nand gates are used throughoutand a ripple-carry design is used, calculate the delay through the adder, assuming all inputs are presented at the same instant, and counting D seconds per gate. Which output signal suers the worst delay.

  What will be the resolution of an 8-bits dac device

If we define the resolution of a Digital-to-Analog Conversion (DAC) device to be the reciprocal of its number of logic states in percentage, what will be the resolution of an 8-bits DAC device

  Explain difference in registered mode and combinational mode

A GAL is different from a PAL because A GAL has more inputs and outputs; A GAL is implemented with a different technology; A GAL can replace several different PAL's; A GAL can be reprogrammed and a PAL cannot

  Design the current divider so that the resistors are less

Design a current divider that will provide a 1/3-2/3 current splitting ratio. Use resistance in kilo ohm range. Redesign the current divider so that the resistors are less than 100 ohms but maintain the same 1/3-2/3 splitting ratio.

  Design the controller and estimator for closed-loop system

design the controller and estimator so that the closed-loop unit step response to a command input has a rise time tr

  Find the maximum value of the power delivered to the circuit

The voltage and current at the terminals of the circuit element are zero for t 0 they are v = 90-90e^(-1000t) V i = 50e^(-1000t) mA A) Find the maximum value of the power delivered to the circuit B)

  What frequency components will be obtained at the output

Given a sawtooth signal with fundamental frequency = 20 KHz as the input signal going into an ideal Highpass Filter with cutoff frequency fc = 60 KHz, what frequency components will be obtained at the output

  Would this improve the performance of the motor

Suppose that we could use superconducting material for the rotor conductors (i.e., rotor conductors with inductance and zero resistance) of an induction motor. Would this improve the performance of the motor? Explain by considering the torque spe..

  Derive equations for the electric flux density for all ?

Given a coaxial cable with solid inner conductor of radius a, an outer conductor that goes from radius b to c (so c>b>a), a charge +Q that is assumed evenly distributed throughout a meter length of the inner conductor

  Define two separate key codes

Implement the design such that the unlock function occurs in the software of the 6811/6812.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd