Determine the frequencies of aliasing noise

Assignment Help Electrical Engineering
Reference no: EM13253365

given analog signal :

x(t)=8cos(6,000pi)+5cos(14,000pit) t>=0

sampled at rate 12,000 Hz

a) sketch the spectorum of the orignal signal and the sampled signal from 0 KHz and 25 KHz.

b) sketch the recovered analog signal spectrum if an anti aliasing filter used.

c) determine the frequencies of aliasing noise , if any

Reference no: EM13253365

Questions Cloud

Design a first-order digital highpass chebyshev filter : Design a first-order digital highpass chebyshev filter (.5-db ripple) with a cutoff frequency of 850 Hz and a sampling frequency of 10 kHz. Determine the transfer function using BLT.
Explain the average atomic mass of phosphorus : Suppose that the atomic mass unit (amu) had been defined as one-sixth of the average mass of an atom of fluorine instead of one-twelfth of the mass of an atom of carbon-12. What would the average atomic mass of phosphorus be on this new scale
What is the voltage across each capacitor : Three capacitors, C1, C2 = 2C1 and C3 = 3C1 are connected in parallel to a voltage source of value V. What is the voltage across each capacitor when all three switches are closed
Does it matter where you are in the project timeline : So how will you as the project manager use this information to ensure project success at completion? Will you be successful? What might get in your way? Does it matter where you are in the project timeline?
Determine the frequencies of aliasing noise : given analog signal : x(t)=8cos(6,000pi)+5cos(14,000pit) t>=0 sampled at rate 12,000 Hz a) sketch the spectorum of the orignal signal and the sampled signal from 0 KHz and 25 KHz.
How would you expect this announcement to affect the value : All other factors held constant, what would be the effect on the demand for money (M1) of each of the following situations. Explain the rationale behind your responses.
Explain the relationship among household disposable : Explain the following statement: "Changes in disposable income lead to movements along the consumption function while changes in wealth lead to a shift of the consumption function." Use examples to illustrate your response.
The zinc electrode immersed in a solution of zinc sulfate : Consider a voltaic cell which has a copper electrode immersed in a solution of copper (II) sulfate and a zinc electrode immersed in a solution of zinc sulfate. determine Eocell. If the concentration of zinc sulfate is 10 times greater than the con..
Explain the use of material requirements planning : Explain the use of "Material Requirements Planning" concepts in manufacturing and Service organizations.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What would be the channel snr for the new system

Binary data is transmitted at the rate of Rb bits/sec over a channel occupying a bandwidth B and the channel SNR=3 dB. If the data bit rate is increased to 2.65Rb and the bandwidth is increased to 1.75B i.

  How much pressure in atmospheres must the submersible

Titan has numerous hydrocarbon lakes containing a mix of methane and ethane in unknown proportions. A small submersible vehicle will exlpore Kraken Mare, the largest lake.

  What does the words leads and lag represent in factor

(1) What does the words leads and lag represent in factor In waveform (2) How would you change the power factor if you needed to

  Determine the requirements of the digital fiters

Determine the requirements of the digital fiters needed and design and write the di erence equations for the digital fiters.

  How the uart can be used to fill an instruction ram

Instead of recreating the design every time we change the instruction ROM, we want to have a way to change the instructions while the system is running. Discuss how the UART can be used to fill an instruction RAM instead

  Calculate the amout of mmf generated by a coil

calculate the amout of mmf generated by a coil of wire having 1300 turns and carrying milliamperes of current?

  Find group delay between the highest modes

Parallel plate waveguide has plate seperation of 2cm, filled with dielectric material with an index refration of n=3, lenght of wavelengh guide z=50m opertaing at 10 Ghz. a) find the cutoff frequency

  Determine the required sampling rate and the data rate

An ultrasound image analog signal needs to be converted to a digital bit stream. The bandwidth of the signal is from 500 kHz to 2.0MHz, and the necessary resolution is 12 bits. determine the required sampling rate and the data rate

  Amplify the signal of a microphone with internal resiatance

What value of emitter resistor would you choose, if: a) You have to amplify the signal of a microphone that has an internal resistance of 100K using a Common Emitter bias configuration b) you have to drive a load of 50 with an Emitter Follower cir..

  What is qualitative difference in cmos nd non-cmos devices

Consider the current it takes to power a +5V 74xx245(Icc). What is the qualitative difference between the CMOS devices and the non-CMOS devices and the non-CMOS devices What is the explanation for the difference

  Define a sinusoidal voltage has a maximum value

A sinusoidal voltage has a maximum value of 100V, and the value is 10V at t=0. The period is T=1ms. Determine v(t)

  Find input current and power factor at maximum torque

A 500 hp, three-phase, 2200 V, 60 HZ, 12-pole, Y-connected, wound-rotor induction motor has the following parameters: R1 = .225 ohm : R'2= .235 ohm Xeq = 1.43 ohm and Xm = 31.8 ohm and Rm = 780 ohm

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd