Determine the foundation soils allowable bearing

Assignment Help Civil Engineering
Reference no: EM13548079

A square footing 2 meters by 2 meters is to be constructed 1.22 meters below the ground surface. The groundwater table is located 1.82 meters below the ground surface. The subsoil consists of a uniform, medium dense, cohesionless soil with the following properties:

Unit weight=18.53 kN/cubic meter

Angle of internal friction=32 degrees

Determine the foundation soil's allowable bearing capacity if a factor of safety of 3 is used.

Reference no: EM13548079

Questions Cloud

High level of activity consists of maintenance cost : High level of activity consists of maintenance cost - company to incur at an operating level of 70,000 directlabor-hours?
Estimated the required volume of the aeration tank : The town of Camp Verde has been directed to upgrade its primary WWTP to a second plant that can meet an effluent standard of 25 mg/L BOD5 and 30 mg/L suspended solids.
What annual volume savings will they achieve if they install : The Pomdeterra wastewater treatment plant produces thickened sludge that has a suspended solids concentration of 3.8 percent. They are investigating a filter press that will yield a solids concentration of 24 percent. If they now produce 33 m^3/d of ..
Determine the dimension of this proposed footing : A proposed square footing carrying a total load of 900 kips is to be constructed on a uniform thick deposit of cohesionless soil. The soil's unit weight is 135 pcf, and its angle of internal friction is 38 degrees.
Determine the foundation soils allowable bearing : A square footing 2 meters by 2 meters is to be constructed 1.22 meters below the ground surface. The groundwater table is located 1.82 meters below the ground surface. The subsoil consists of a uniform, medium dense, cohesionless soil with the follow..
Determine the factor of safety of this trench by the culman : A 1.5 meter deep vertical wall trench is to be cut in a soil whose unit weight is 17.36 kN/cubic meters, angle of internal friction is 25 degrees, and cohesion is 20.6 kN/square meters. Determine the factor of safety of this trench by the Culmann Met..
Estimate the maximum force that a water jet from : A pressure washer or power washer is a machine commonly used to clean mildew and dirt off houses, driveways, sidewalks etc. It attaches to a common garden hose
Interpret the slope. : Interpret the slope.
You are asked to design a winch system : You are asked to design a winch system for Santa's sleigh. Assume that Santa weighs 300 lbs, visits 10 houses an hour and requires a 20 foot lift at each house, what is the average power that the system will use if it is perfectly efficient? Express ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what is the acceleration of diatomic oxygen gas

2 kilomoles of diatomic oxygen gas are enclosed in a 10-kg steel container. A force of 2kN now accelerates this system. What is the acceleration

  Write material balance to describe rate of change in amount

Draw a diagram of the room with all of the important parameters noted with symboles. Write a material balance to describe the rate of change in the amount of benzene in the air of the room starting from the time the bottle was opened onwards.

  Effect of acidic water on strength of soil used to store

effect of acidic water on strength of soil used to store the water. the reduction in strength at various acidic ph

  Determine the elapsed time after removal from the pouch

Consider a DVD To protect sensitive information within the storage medium, a vwery thin film of reactive polymer is embedded within the polycarbonate at a distance of d= 0.5 mm from the surface.

  Plan your field geotechnical instrumentation scheme

Plan your field geotechnical instrumentation scheme. Plot your instrumentation systems on a cross section of your embankment and fully justify your answer. Also remember that you need to obtain the maximum data with the minimum cost?

  Determine the governing load combination for both moments

A beam that is part of a rigid frame has end moments and mid-span moments for dead, live, and earthquake loads. Determine the governing load combination for both negative and positive moments at the ends and mid-span of the beam.

  Determine groundwater flow per unit width of the aquifer

The piezometer A is located 4,000 ft south of piezometer B.  Approximately 3,000 ft of piezometer B there is a river with an elevation relative to sea level of about 455 ft.

  Determine the factor of safety against overturning about

determine the factor of safety against overturning about point a if 3 .the factor of safety is defined as the ratio of

  Analyze a structural system of a building

Use modern software tools to analyze a structural system of a building.

  Slope deflection approach to find complete deflection

Use slope deflection approach to find complete deflection solutions for a fixed fixed beam with concentrated force, F, distance a from left end and axial load P.

  Whats is the equivalent co2 emission rate of the total

n 2006, the united states emitted 6,000 million metric tons (Mt) of CO2, 26.6 MtCH4, and 1.2 MtN2O. using 100 year global warming potentials, whats is the equivalent CO2 emission rate of the total for these three gases, in GtC-eq/yr

  Would it still be normally consolidated with the water

Estimate the value of the coefficient of at-rest earth pressure forthe deposit. If, when the water table was at the ground surface, the deposit was normallyconsolidated,would it still be normally consolidated with the water tablelowered? A reason mus..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd