Determine the force p required to pull the shaft

Reference no: EM13556968

A 25-mm diamenter shaft is pulled through a cylindrical bearing as shown. The lubricant that fills the 0.3-mm gap between the shaft and bearing is an oil having a kinematic velocity of 8.0x10^-4 m^2/s and a specific gravity of 0.91. Determine the force P required to pull the shaft at a velocity of 3 m/s. Assume the velocity distribution in the gap is linear.

Note: picture not shown but length is 0.5m. This is also question 1.38 in the 4th edition-The one that is poping up is not the right one.

Reference no: EM13556968

Questions Cloud

What is the percent change in the area of the glass : A window pane of dimensions 0.75 m x 0.65 m is installed on a day when the temperature is 35F. What is the percent change in the area of the glass

Determine how much heat flowed in this process : A 0.70kg piece of lead at a temperature of 160C is dumped into 800mL of water at a temperature of 22C , How much heat flowed in this process

Find the total energy stored in the capacitors : Two parallel plate capacitors of area A = .002m^2 each, and plates separations of 5.00 mm, 8.85mm and are connected in parallel and then connected to a 120 volts battery. Find the total energy stored in the capacitors

Determine the magnitude of the heat the athlete gives off : Heat engines take input energy in the form of heat, use some of that energy to do work, and exhaust the remainder. Determine the magnitude of the heat the athlete gives off

Determine the force p required to pull the shaft : A 25-mm diamenter shaft is pulled through a cylindrical bearing as shown. The lubricant that fills the 0.3-mm gap between the shaft and bearing is an oil having a kinematic velocity of 8.0x10^-4 m^2/s and a specific gravity

What is the effective spring constant of this system : Imagine you had two identical springs, each with spring constant k. what is the effective spring constant of this system

How does this compare with the exact value : Repeat LEM(Limit Equilibrium Method) analysis in clay (undrained) using a circular failure surface, with the center of the circle a distance h above the edge of the footing. What ratio of h/B gives the minimum value of Nc? How does this compare with ..

Dram and sketch the system. include coordinate system : A plate is pulled upward from a pool of liquid with velocity, V, entering a thin liquid film on the surface of the plate. The flow is assumed to be laminar and the film thickness

What will be the mean velocity in each port : Water enters the lock of a ship canal through 180 ports, each port having a 2 ft by 2 ft cross section. The lock is 900 ft long and 105 ft wide. The lock is designed so that the water surface in it will rise at a maximum rate of 6 ft/min.

User Account

All Pages