Determine the force exerted on th mass in the direction

Assignment Help Civil Engineering
Reference no: EM13555168

A 150 kg mass is suspended by wires from two hooks. the lengths of the wires have been adjusted so that the wires are each 50º from horizontal. assume that the mass of the wires is negligible.

a) Two hoops support the mass equally so the vertical component of force exerted by either hook will be equal to the force result ion from 75 kg being acted on gravity. calculate this vertical component of force,

ƒ_v on the right hook. express you result in newtons.

b) Compute the horizontal component of force ƒ_h by using the result obtained in part (a) and trigonometry.

c) Determine the force exerted on th mass in the direction of the wire F_R (equal to the tension in the wire

d)If you moved the hooks farther apart to reduce the angel from 50º to 30º would the tension in the wires increase or decrease? why?

Reference no: EM13555168

Questions Cloud

What is the discharge rate per unit width of the aquifer to : To avoid the salinization of soil in a farming area, parallel drainage canals are to be installed to maintain the water table at a depth of at least 4m below the ground surface. It is thought that no evapo-transpiration would occur below that depth.
What is the alkalinity of this water expressed as mg/l : A water sample contains 118mg/L of bicarbonate ion, 19mg/L of carbonate ion, and has a pH of 9.5. What is the alkalinity of this water expressed as mg/L of CaCO3?
What is a chance that a driver who has a positive breathalyz : A police officer stops a speeding driver on saturday nigt and gives hima breathalzer test. the test shows that his estimated blood alcohol content is above .08 g/dl, and this is considered evidence of driving while intoxicated
Do you think the gravel will be scoured by the flowing water : The bottom is a 6 in slab of rough concrete. If the water is flowing at a uniform depth of 6 ft, do you think the gravel will be scoured by the flowing water
Determine the force exerted on th mass in the direction : A 150 kg mass is suspended by wires from two hooks. the lengths of the wires have been adjusted so that the wires are each 50º from horizontal. assume that the mass of the wires is negligible.
Calculate the normal force n exerted by the side of the slot : The flat circular disk rotates about a vertical axis through O with a slowly increasing angular velocity ?. Prior to rotation, each of the 0.60-kg sliding blocks has the position x = 29 mm with no force in its attached spring. Each spring has a stiff..
Determine the shear stress at each wall and the maximum : Sketch and identify the Tresca (maximum shear stress) and von Mises (maximum distortion energy) failure criteria in two-dimensional principal stress space (i.e., ?2 vs. ?1) for the above material.
What are the northing and easting coordinates for station b : The coordinates for station A are 1023.34 N and 988.56 E. What are the northing and easting coordinates for station B that is located 40 feet due east of A, and 22.32 feet due south of A
Find the maximum allowable tensile force : A 4-cm- diameter rod of aluminum 7075-T6 is to subjected to an axial tensile force such that the factor of safety based on the yield stress on 1.75. Find the maximum allowable tensile force. The yield stress of the aluminum 7075-T6 is o-y= 500MPa.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Percent by weight of limestone

A slurry containing 20 percent by weight of limestone (CaCO 3 ) is processes to separate pure dry limestone from water. If feed rate is 2000kg/h, how much CaCO 3 is produced per hour?

  Determine specific gravity if vol of the pot is 450ml

While washing up Grandma's old aluminum cooking pot I noticed that it would just barely touch the bottom of the sink if I added 2.5 cups of water to it. The pot is 3.5 in high and 9.5 in diameter. Thickness of aluminum is 3/16 in.

  What reading of the compass should be used to retrace line

IT IS DESIRED TO RETRACE THE LINE WITH A COMPASS TODAY, WHEN THE DECLINATION IS 5 35'E. WHAT READING OF THE COMPASS SHOULD BE USED TO RETRACE THE LINE

  Determine the critical path-starting and finishing times

Activity Description Duration Immediate Predecessors ST Start milestone - Activity Description duration Inmdiate predesesor ST Start milestone - - A excavate st. 1 4 ST B Order & steel del. work 7 ST C Formwork st.

  How to design a pump system with certain requirments

The pump graphs are given to us, and I'm asked to determine possible lengths and diameters of the pipe to meet two requirments. The system can have multiple outputs in order to satisfy the needs, but they must be occuring at the same time.

  Determine the velocity and thermal boundary layer thickness

Engine Oil at 60 degrees C flows over a 3m long and 2m wide plate whose temperature is maintained at 20 degrees C with a velocity of 2 m/s. Determine the rate of heat transfer from the entire plate.

  Determine maximum shearig stress in the shaft

a hollow steel shaft with an outside diameter of 400 mm and inside diameter of 300mm is subjected to the torque of 300 Kn. The modulus of rigidity for the steel is 80 GPa.

  Determine the minumum coeffeicient of friction

A water jet of diameter 2 inches and speed of v=60 ft/s is filling a tank at a 70 degree angle. The tank has a mass of 25 lbm and contains 6 gallons of water. The water temperature is 70 degrees F.

  Estimate low-dose cancer risk from occupational inhalation

this concentration is based on an assumption that the individual is generally healthy and is exposed for 8 hours per day over a working lifetime ( that is from age 18 to 65 years). assuming a body weight of 78 kg and an inhalation rate of 0.63 m^3..

  Compute the void ratio porosity initial moisture content

A soil initially has a degree of saturation of 95% and a unit weight of 129 lb/ft3. It is then placed in an oven and dried. After removal from the oven, its unit weight is 109 lb/ft3. Compute the void ratio, porosity

  Determine what is the stationing of the pc and pt

A horizontal curve is being designed through mountainous terrain for a four-lane road with lanes 10 ft. wide. The central angle is known to be 40 degrees, the tangent distance is 520 ft., and the stationing of the tangent intersection (PI) is 2600..

  Determine the water depth at 30 m upstream of the brink

The channel entrance is rounded and smooth (negligible head loss at entrance), and the reservoir water surface is 2.5 m above the bed of the channel at the entrance. hf=0.00019*Q2, where Q (in m3/s) is the discharge in the channel.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd