Determine the following the force acting on a 1 m2 surface

Assignment Help Mechanical Engineering
Reference no: EM13627702

1) Determine the following:

a) The force acting on a 1 m2 surface corresponding to a 1 kPa pressure applied over the entire surface.

b) The work done lifting a 10 N (Newton) weight vertically upwards 20 m.

c) The density of air if the specific volume is 0.85 m3/kg.

d) The gravitational potential energy of a 25 kg mass 40 m above a reference level.

e) The kinetic energy of a 100 kg object travelling at 20 km/h.

Reference no: EM13627702

Questions Cloud

The counting rate from a radioactive source is 8000 countss : the counting rate from a radioactive source is 8000 countss at time t0 while 10 mins later the rate is 1000 countss.a
If the force of the spring on the cylinder is f gt 100s13 : the cylinder has a weight of 22 lb and is pushed against a series of belleville spring washers so that the compression
A 100 komega resistor and a capacitor are connected in : a 10.0 komega resistor and a capacitor are connected in series and then a 10.0 v potential difference is suddenly
Coming out of a factory chimney are the following gases : coming out of a factory chimney are the following gases co2 so2 o2 n2 h2o with volume percentage to be 13.5 0.3 5.2 76
Determine the following the force acting on a 1 m2 surface : 1 determine the followinga the force acting on a 1 m2 surface corresponding to a 1 kpa pressure applied over the entire
The constant a in van der waals equation is 0547 jm3mol2 : the constant a in van der waals equation is 0.547 jm3mol2 and b is 30.52 x 10-6 m3mol for water vapor.a. compute the
Coming out of a factory chimney are the following gases : coming out of a factory chimney are the following gases co2 so2 o2 n2 h2o with volume percentage to be 13.5 0.3 5.2 76
Find an interval centered on the mean in which we can : a large sample of people each overweight volunteered to go on the same diet and showed that the average weight loss was
What is the probability that the sample mean fne score is : data from a psychology experiment were reported and analyzed in the american statistician may 2001. each student

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Hydrogen at 25 bar 450degc enters an adiabatic turbine and

hydrogen at 25 bar 450degc enters an adiabatic turbine and expands to 2 bar 160degc with a mass flow rate of 0.2 kgs.

  Compute the position of the quasi-fermi

calculate the position of the quasi-Fermi levels for electrons and holes with respect to the intrinsic level (assume that ni=1.5x10^10cm^-3).

  What time will be required at 500degc to produce the same

the wear resistance of a steel shaft is to be improved by nitrogen hardening of its surface. the initial nitrogen

  The bar is loaded axially until it elongates 65mm and then

a bar of length 2.0 m is made of a structural steel having the stress-strain diagram shown in the figure. the yield

  Determine the magnitude of the acceleration of the child

a child a is swinging from a swing that is attached to a trolley that is free to move along a fixed rail. letting l

  Calculate compression ratio cr pressure and temperature at

a six cylinder diesel engine with a 4.5 inch. bore for each cylinder and 5.0 inches stroke works on a theoretical

  A furnace needs hot pressurized gas at 200 kpa this gas is

a furnace needs hot pressurized gas at 200 kpa. this gas is to be provided by the exhaust from a gas turbine operating

  Refrigerant 134a undergoes a constant pressure process from

refrigerant 134a undergoes a constant pressure process from saturated vapor at -18.8degc to a final temperature of

  A civil engineer must design a wheelchair accessible ramp

a civil engineer must design a wheelchair accessible ramp next to a set of steps leading up to a building. the height

  Saturated r-12 enters the compressor at a temperture of -10

a medical warmer operates using a heat pump. saturated r-12 enters the compressor at a temperture of -10 c and exits as

  An ideal vapor-compression refrigeration cycle opperates at

an ideal vapor-compression refrigeration cycle opperates at steady state with refrigeratn 134a as the working fluid.

  Determine the mass flow rate of steam

Steam enters a diffuser at 20 psia and 240oF with a velocity of 900 ft/s and exits as saturated vapor at 240oF and 100 ft/s. The exit area of the diffuser is 1 ft2. Determine (a) the mass flow rate of steam and (b) the rate of entropy generation.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd