Determine the flow rate of the refrigerant and coefficient

Assignment Help Chemical Engineering
Reference no: EM131156580

Problem 6.30:

Design a vapor compression refrigeration unit using R290 as the refrigerant. The unit must be capable of pumping 1.5 refrigeration tons of heat at -25 °C. The condenser will be operated using water at 25 °C. Determine the flow rate of the refrigerant and the coefficient of performance assuming the compressor to operate with 80% efficiency. Additional information: One standard refrigeration ton is 12,000 BTU/h (3,517 W).

Problem 6.31:

The process shown in Figure 6-19 is part of a chiller unit that uses water as the refrigerant. The following data are available: stream 1 is a vapor-liquid mixture at 0.5 bar; stream 5 is saturated vapor at 5 °C; stream 6 is at 500 °C; stream 7 is at 100 °C. Calculate the following on the basis of 1 kg/s of water in stream 1:

1908_b577d40b-8428-4e17-b2c4-b0353765924d.png

Reference no: EM131156580

Questions Cloud

Prepare a presentation that summarizing your findings : Prepare a PowerPoint presentation of 8-12 slides summarizing your findings. Be sure to use graphics or illustrations to enhance your presentation.
What is the function of mar : What is the function of MAR? MDR / MBR? IR? control bus?
Asset tracking and management software application : Background: You are part of a team that will be implementing an asset tracking and management software application. Choose an organization with which you are familiar for this assignment.
Inventory turnover is the traditional metric : Inventory Turnover is the traditional metric for judging the effectiveness of a supply chain. C2C (Cash-to-Cash) is quickly supplementing, and some experts say, replacing Inventory Turnover as the major supply chain metric. Why do you think that ther..
Determine the flow rate of the refrigerant and coefficient : The process shown in Figure 6-19 is part of a chiller unit that uses water as the refrigerant. The following data are available: stream 1 is a vapor-liquid mixture at 0.5 bar; stream 5 is saturated vapor at 5 °C; stream 6 is at 500 °C; stream 7 is..
How does mpls work : How does MPLS work? Compare and contrast dedicated-circuit services and packet-switched services.
Explain your definition of production operation management : Elaborate your own definition of production operations management, including manufacturing and service operations. Then, assess the implication of technology in your definition.
Dmz zone in a businesses : Should there be a DMZ zone in a businesses so staff can access their personal email, social media? Name four reasons why.
Find the line currents and the total complex power : Find the line currents and the total complex power delivered to the load.- Assume VAB to be 230 ∠ 0° V and the phase sequence to be positive.

Reviews

Write a Review

Chemical Engineering Questions & Answers

  What is the energy in joules required for the incident light

Compare the energy of the incident light with the rest energy of the earth using Einstein's mass-energy equivalence equation E = mc2, where the mass of the earth is 6 x1024 kg.

  What is the composition of the original solution

A solution that contains nitromethane in acetonitrile is heated at constant pressure of 1 bar until the first bubble appears. If the temperature at this point is 85 °C, what is the composition of the original solution?

  Sketch the timing diagram for a 4-bit ripple counter

Using T flip-flops, show the block diagram for a 3-bit ripple counter and its input and output waveforms.

  How much must transmit power be increased

How much transmit power is required (disregarding power losses at transmitter and receiver ends) for a maximum BER of 10-5, when using:a. Coherently detected BPSKb. By how much must transmit power be increased to maintain the maximum BER of 10-5 if t..

  Ideal gas law air at 4mpa and 3000c enters a will

air at 4mpa and 3000c enters a will insulated turbine operating at steady state with negligible velocity. the air

  Explain risk analysis and management

Risk Analysis and Management: Earthquake - An example of Fragility and Load, The fully formated problem is with the solution.

  Calculate the feed ratio

Two aqueous sulfuric acid solutions containing 20.0 wt% H2SO4 (SG = 1.139) and 60.0 wt% H2SO4 (SG = 1.498) are mixed to form a 4.00 molar solution (SG = 1.213).

  Find the magnitude of the output as a function of frequency

Suppose the operational amplifier in the following circuit is ideal.

  Determine the final pressure and temperature in the tank

The ideal-gas heat capacities of ethylene and nitrogen are 43 J/mol K and 29 J/mol K, respectively, and may be assumed independent of temperature.

  Calculate the instantaneous and rms values of the voltage

Calculate the instantaneous and rms values of the voltage induced in a 150-turn coil on the armature, if the axial length of the armature and its inner diameter are both 100 mm.

  Overall concepts of various management functions

Develop an understanding of overall concepts of various management functions - Demonstrate knowledge of acquisition of information

  Compute the power factor for zero voltage regulation

Compute the power factor for zero voltage regulation on full load.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd