Determine the flow of vehicles on the level section

Assignment Help Civil Engineering
Reference no: EM13312689

rom a photograph one observes that on a level section of highway 10% of the vehicles are trucks, 90% are cars, and that there are 50 vehicles per mile of highway. The trucks travel at 40 mph, and the cars at 50 mph. This highway also has a section with a steep grade on which the speed of the trucks drops to 20 mph, and the speed of the cars to 40 mph. No vehicles enter the observed sections of highways (except at the ends), and the flows are (nearly) stationary.

Determine:

(a) The flow of vehicles on the level section.

(b) The density of vehicles on the grade.

(c) The percent of trucks on the grade as seen on a photograph.

(d) The percent of trucks as seen by a stationary observer on the grade

Reference no: EM13312689

Questions Cloud

What is the magnitude of the acceleration of the proton : A proton accelerates from rest in a uniform electric field of 524 N/C. What is the magnitude of the acceleration of the proton
Explain the silver-silver chloride electrode : Suppose that the silver-silver chloride electrode in the figure is replaced by a saturated calomel electrode. Calculate the cell voltage if [Fe2+]/[Fe3+] = 5.0 10-3. V
What would you consider some of the key considerations : Explain your choices. Is the organization you work for (or one that you are familiar with) meeting these key considerations?
Explain what is the value of n for the level : An electron in the n = 7 level of the hydrogen atom relaxes to a lower energy level, emitting light of 93.1 nm. What is the value of n for the level to which the electron relaxed
Determine the flow of vehicles on the level section : rom a photograph one observes that on a level section of highway 10% of the vehicles are trucks, 90% are cars, and that there are 50 vehicles per mile of highway. The trucks travel at 40 mph, and the cars at 50 mph.
Calculate the amount of each phase present in a 1-kg alumina : Calculate the amount of each phase present in a 1-kg alumina refractory with composition 70 mol % Al2O3- 30 mol% SiO2 at 2,000 C , 1,900 C and 1,800 C
Explain if the molar solubility of cd3(po4)2 : If the molar solubility of Cd3(PO4)2 at 25 oC is 1.19e-07 mol/L, what is the Ksp of Cd3(PO4)2 at this temperature
How far away are the cliffs : you are on a boat in a fog and know there are cliffs ahead of you somewhere, but you cannot see them. How far away are the cliffs
How many particles would be present in a cubic meter : How many particles would be present in a cubic meter of aerosol at the concentration of the U.S. PM-10 standard or 50 micrograms/cubic meter if the particles are .1 micrometer in diameter.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what is the darcy velocity of the groundwater

An unconfined, gravel-sand aquifer has a porosity of 0.23, and a hydraulic conductivity of 1000 m/day. Two monitoring wells are 260 m apart, and the difference in their water levels is 0.3 m.

  Find what is the outflow effluent g-loop concentration

A completely mixed continous bioreactor used for growing oenicilin operates at a zero orer system. The input glucose is converted into various organic yeats. the flow rate ti this system is 20 liters per minute and the conversin rate is 4 mg/(min-..

  Determine what manometer reading can be expected

Is this flow laminar. What is the viscosity of the oil. For the same flow in the opposite directio, what manometer reading can be expected.

  Develop a simple urban constructed wetland design

Develop a simple urban constructed wetland design.

  Find the factor of safety based on the ultimate force

An eighteen inch diameter sandstone column is subjected to an axial compressive force of 2x10^6 lb / ft. Find the factor of safety based on the ultimate compressive force. For the ultimate compressive stress of sandstone=85Mpa.

  Determine the sludge age and cell wastage flow rate

Assume: Suspended solids in effluent negligible Wastage is from aeration tank Yield coefficient = 0.4 Bacterial decay rate = 0.04 1/d Effluent BOD5 = 10mg/L F/M = 0.33 mg/mg*d BOD5 after primary settling = 150mg/L MLVSS = 1700mg/L MLSS = 1.4(MLVSS..

  Compute the parts of the curve including t-l-lc-e-m and d

A simple horizontal curve of radius 750 ft connects two tangents that intersect at an angle of 66º30'. Compute the parts of the curve, including T, L, LC, E, M, and D.

  How many meters of the block will be above the oil

a 2m cube of block is placed on oil ( SG= 0.8). if the SG of the block is 0.6, how many meters of the block will be above the oil

  Design the thinnest possible slab allowed by the aci code

Design a simply supported one-way reinforced concrete floor slab to span 10 ft and carry a service live load of 175 psf and a service dead load of 25 psf. Use fc' = 3000 psi and fy = 60,000 psi. Make the slab thickness to ½-in. increments.

  How to approximate the number of the 120 intervals

At a specified point on a highway, vehicles are known to arrive according to a poisson process. Vehicles are counted in 20 second intervals, and vehicle counts are taken in 120 of these time intervals.

  Compare the physical migration of workers

Compare the physical migration of workers during U.S. industrialization and present-day intellectual transition into a new type of workforce.

  Superelevation rate for a roadway

What superelevation rate would you recommend for a roadway with a design speed of 100 km/hr and a radius of curvature of 500 m? Assume f = 0.11.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd