Determine the fine grains of low plasticity

Assignment Help Civil Engineering
Reference no: EM13306327

Two soil sandy-silt-clay, A and B have the same particle size distribution curve. Soil A is micaceous with an average grain relative density of 2.80, and has a high plasticity in its fine fraction. The ground quartz-feldspathic B is, with an average relative density of 2.65 and fine grains of low plasticity. Based on this information, ask:

a) it would be possible to say if one of these soils is potentially more compressible than the other?

b) it would be expected that these two soils, when saturated, have different humidities?

Reference no: EM13306327

Questions Cloud

Find what is the builder capitalized cost to const the plant : A home builder must construct a sewage treatment plant and deposit sufficient money in a perpetual trust fund to pay the $5000 per year operating cost and to replace the treatment plant every 40 years.
Explain why this relation is not normalized : Assume that ProjectNumber determines ProjectName and explain why this relation is not normalized?
Determine what is the void ratio of the soil : A natural deposit of soild was found to have water content of 20% and to be 90% saturated. What is the void ratio of the soil
What is the accuracy of a two-bit predictor : What is the accuracy of a two-bit predictor, assuming the predictor starts off in the bottom left state? What if the pattern repeats forever?
Determine the fine grains of low plasticity : Soil A is micaceous with an average grain relative density of 2.80, and has a high plasticity in its fine fraction. The ground quartz-feldspathic B is, with an average relative density of 2.65 and fine grains of low plasticity.
Calculate and display the total retail value of all products : It should calculate and display the total retail value of all products sold. Use a sentinel-controlled loop to determine when the application should stop looping display the final results.
Obtain the frequency of the motion : A vertical spring (spring constant =165 N/m) is mounted on the floor. A 0.390-kg block is placed on top of the spring, Obtain the frequency (in Hz) of the motion
Create derived subclass called brighteyes : Create derived subclass called BrightEyes for the italicized class code below.
Find the amplitude of the simple harmonic motion : A microphone is attached to a spring that is suspended from the ceiling, as the drawing indicates.  determine the amplitude of the simple harmonic motion

Reviews

Write a Review

Civil Engineering Questions & Answers

  How to formulate a set of constraints that will enforce

Given the binary variables x1,x2,x3,x4 and x5, formulate a set of constraints that will enforce x3,x4, and x5 to equal one if x1=1 and x2=0.

  Calculate the change in the spheres internal energy in kj

During the process 40 kJ of heat is transferred from the sphere, while the sphere receives energy in the form of work equal to 20kcal. calculate the change in the sphere's internal energy in kJ.

  Find the moment of inertia and natural frequency of pipe

Find the moment of inertia and natural frequency of a vertical cantilever pipe 12 feet tall with outer diameter of 4.5 inches and an inner diameter of 4.25 inches. Modulus of Elasticity = 10*10^6 Mass = 50 lbs.

  Determine depth of water flow in rectangular channel

Find depth of water flow in Rectangular channel, Water is flowing in a rectangular channel whose width is 5m

  Find the value of the angle at which the projectile is fired

A projectile is fired with an initial velocity of 800 ft/s at a target B located 2000 feet above the gun A and at a horizontal distance of 12,000 feet. Neglecting air resistance, determine the value of the angle at which the projectile is fired.

  Calculating sand shear strength

Estimate the effective friction angle for the sand (assume c' = 0). Calculate the sand's shear strength (τf) on a horizontal plane at depths of the 20 ft and 50 ft.

  What is the normality of a sodium hydroxide solution

What is the normality of a sodium hydroxide solution that contains 250 mg/L NaOH in 2.3 L solution? What is the concentration in mole/L and mg/L as CaCO3. Na = 23, OH = 17

  Pharmaceutical mixing tank

In year one, a pharmaceutical mixing tank had a market price of $120,000. It replaced an older smaller mixing tank that had a BV of $15,000.

  How high can the hump be made without backing flow up

A smooth hump is placed in the bottom of the channel. What would be the depth of flow over a 3 ft high jump. How high can the hump be made without backing flow up What would be the depth of flow over and just upstream of a 6 ft high jump

  What are the velocities of both just before and after impact

What are the velocities of both just before impact and just after impact. There is a distance of 5m between the vehicles prior to the winch being turned on.

  How many days would wastewater take to fill the lagoon

a lagoon is 20 ft by 80 ft with a depth of 5.5 ft .Wastewater from households flow into the lagoon at 260 gal/day .How many days would it take to fill the lagoon

  Calculate how much energy must be added to the system

A piston-cylinder contains 40 kg water of which 20 kg is saturated liquid. The equilibrium pressure of the system is 100 kPa. a) Find the system initial volume b) The water undergoes an isothermal expansion until the pressure reaches 10 kPa.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd