Determine the final speed of the cart

Assignment Help Civil Engineering
Reference no: EM13531082

Two men A and B, each having a weight of 160lb stand on a200lb cart. Each runs with a speed of 3ft/s measured relativeto the cart. Determine the final speed of the cart if:

a) A runs and jumps off, then B runs and jumps off the sameend

b) both run at the same time and jump off at the sametime.

Neglect the mass of the wheels and assume the jumps are madehorizontally.

Reference no: EM13531082

Questions Cloud

Determine the average normal stress developed in each post : The rigid block has a weight of 80 kip and is to be supportedby posts A and B, which are made of A-36 steel, and the post C,which is made of C83400 red brass.
Determine the maximum allowable temperature rise : Determine the maximum allowable temperature rise if the allowablecompressive stress in the copper is σ(allowable) = 19,500 psi.
Determine the maximum shear stresses : A solid steel bar of diameter 30 mm is enclosed by a steel tube of outer diameter 45 mm and inner diameter 36 mm. Both bar and tube are held rigidly at end A and joined securely to a rigid plate at end B. The composite bar, which is 500 mm long, is t..
When analyzing a truss using the method of sections to find : When analyzing a truss using the method of sections to find theforces in specific members. What is a good strategy to helpdecide where to make the cuts to separate the truss into separatesections?
Determine the final speed of the cart : Two men A and B, each having a weight of 160lb stand on a200lb cart. Each runs with a speed of 3ft/s measured relativeto the cart. Determine the final speed of the cart if:
How much flow human lung can deliver cold soda and/or water : One hundre cubic meter of gas at-34.6c celcius and 200kpa in absolute pressure is compressed to a volume of 25 cubic meter and  an absolute pressure of 1000kpa. what is the new temperature, in degrees celsius?
Fresh water fish do not survive in water : If the concentration of glucose in plasma is 5 mM, and theintracellular glucose concentration is negligible (i.e. 0 mM), whatis the rate of glucose diffusion (J) into the cell? Assume that thethickness of the plasma membrane is 10 nm.
What safety factor will be necessary to allow an extraction : A lead-zinc mine is to be developed by a room-and-pillar layout.  The mine is located at a depth of 500ft, the overlying rock has an average specific gravity of 2.56, and the pillar rock wast tested and found to have a
What is the composition of the last solid remaining prior : What is the composition of the last solid remaining prior tocomplete melting?

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the pressure in pipe at point a consider friction

A reservoir discharge into a 60-inch concrete pipe (rough surface) that discharges freely. what is the pressure in the pipe at point A consider friction, but neglect minor losses.

  Express samples hardness in meq per l and mg per l of caco3

Hardness is sum of all divalent cations (meaning all species with a positive charge of 2) in a water sample. Magnesium (Mg2+) and calcium (Ca2+) are the most common divalent cations that contribute to hardness.

  State difference in bishop and fellenius method of slices

State the basic difference between the general method of slices and the bishop method of slices. b.)State the basic difference between the bishop and fellenius method of slices

  Calculate the mass flow rate for the concentrate stream

A magnetic separator processes 500 kg/hr of finely ground magnetite ore (Fe3O4). The ore containes 35% magnetite and an analysis of the concentrate and tailings shows that they contain 59.5% Fe and 3.8% Fe

  What is the distance uncertainty at the surface of ellipsoid

if a hand-held GPS unit locates a latitudinal position with an uncertainty of + - 0.02-seconds, what is the distance uncertainty at the surface of the ellipsoid.

  Compounds empirical and molecular formula

A Silane contains 90.31 % silicon and 9.69 % hydrogen by mass. The compound has a molar mass of 62 g/mol. Determine the compound's empirical and molecular formula.

  What is magnitude of total external force on the helicopter

During a test flight in which a 9000-kg helicopter starts from rest at t = 0, the acceleration of its center of mass from t =0 to t =10 s is a=(0.6t)i+ (1.8 0.36t)j m/s2.

  How many yards of borrow is require to complete construction

an embarkment will be constructed with the soil compacted to 95 percent of the max dry density. the borrow material, is deposited at a uniform density of 75 percent of the max dry density. the roadway embankment will require 75,000 cubic yards of ..

  Estimate the ground level so2 at a point of the power plant

A power plant emits 95 g/s of SO2 from an effective stack height of 60 m. The wind speed is 3 m/s and the solar insolation is slight. A) Estimate the ground level SO2 (ug/m^3) at a point 4 km directly downwind of the power plant

  Determine the centroid-moment of inertia and section modulus

THE HOME DEPOT IN RED HOOK ,BROOKLYN IS LOOKING TO RENOVATE THEIR STEEL ROOF TRUSS.YOU HAVE BEEN ASKED TO DETERMINE THE CENTROID,MOMENT OF INERTIA,SECTION MODULUS AND RADIUS OF GYRATION OF THE DOUBLE ANGLE.

  Calculate the largest tolerable internal crack length for a

calculate the largest tolerable internal crack length for a 7075-t651 aluminum alloy component that is loaded to a

  Find the force in each member for a truss not at the ends

Roof trusses such as the one shown are spaced 6 m apart in a long, rectangular building. During the winter, snow loads of up to 1 KN/m^2 (or 1 KPa) accumulate on the central portion of the roof. Find the force in each member for a truss not at the..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd