Determine the exit velocity of the nitrogen

Assignment Help Mechanical Engineering

Reference no: EM13709592

Nitrogen gas at 65kPa and 7C enters an adiabatic diffuser steadily with a velocity of 210 m/s and leaves at 119kPa and 22C. Determine

a) the exit velocity of the nitrogen

b) the ratio of the inlet to exit area

Reference no: EM13709592

Questions Cloud

Kinetic energy of the air within the chamber is negligible : An air cushion vehicle is supported by forcing air into the chamber created by a skirt around the periphery of the vehicle as shown in Fig. P3.106. The air escapes through the 1.7-in. clearance between the lower end of the skirt and the ground (or wa..

Determine the size of the contact patch and contact stresses : Determine the size of the contact patch, the contact stresses, and the maximum shear stress for a 40 mm diameter steel cylinder, 25 cm long, rolled against a flat plate with a 4 kN force pressing the cylinder onto the flat plate.

Masses connected together with a mass less rigid-link : Given three masses connected together with a mass less rigid-link, where should you place the single mass if you want to replace these masses with it?

Steam enters diffuser operating steady state with pressure : Steam enters a diffuser operating at steady state with a pressure of 14.7 psi, a temperature of 300F, and a velocity of 500ft/s. Steam exits the diffuser as a saturated vapor with negligible kinetic energy. Heat transfer occurs from the steam to its ..

Determine the exit velocity of the nitrogen : Nitrogen gas at 65kPa and 7C enters an adiabatic diffuser steadily with a velocity of 210 m/s and leaves at 119kPa and 22C. Determine the exit velocity of the nitrogen. the ratio of the inlet to exit area

What must be the surface area of the lift cylinder : A hydraulic lift must lift 7000 lbs using oil that is under pressure of 130 lbs/in^2. what must be the surface area of the lift cylinder?

Exceptional thermal-insulation properties : The thermal protection system for NASA's Space Shuttle Orbiter was effective due to its exceptional thermal-insulation properties. Calculate the heat flow (per square meter) across a 50-mm-thick ceramic tile with an outer surface temperature of 1200 ..

The amount of heat transfer during the whole process : 1.5 kg of air in a piston/cylinder assembly has initial temperature and pressure 27oC and 1.5 bar respectively. Then the system is heated in constant volume to 727oC (state 1-2) and then heated again constant pressure to 1227oC (state 2-3).Determine ..

Maximum tensile and compressive stress acting on the beam : If the built-up beam is subjected to an internal moment of 75 kn*m, determine the maximum tensile and compressive stress acting on the beam

User Account

All Pages