Determine the emission rates of each carpet

Assignment Help Other Subject
Reference no: EM131406383

Assignemnt: Indoor Air Quality (& Ventilation) Department of Building, Civil & Environmental Engineering Faculty of Engineering and Computer Science

1. The samples of two different carpets were tested for VOC emissions in 20m3 environmental chamber made of stainless steel. Dynamic tests were conducted under the following conditions:

- Temperature: 23oC
- Relative humidity: 50%
- Air exchange rate: 1 hr-1
- Loading factor: 0.44 m2/m3

The following test results (chamber concentrations in ug/m3) for 4-phenylcyclohexene (4- PCH) were obtained.

Time [hr]

Carpet A

Carpet B

3.0

42.8

48.5

6.0

44.0

44.7

12.0

40.4

36.5

24.0

37.0

34.8

48.0

34.3

29.8

72.0

31.2

29.4

96.0

30.8

25.2

120.0

28.6

23.8

144.0

26.6

21.6

168.0

26.8

20.9

a) Using the mass balance equation, determine the emission rates of each carpet (as a function of time)

b) After one-week of airing out, each carpet was installed wall-to-wall in an identical open- plan office with constant volume ventilation system. The area of the office is 2000 ft2 (185.8 m2) and the number of expected occupants is 10. Assuming the carpets are the only source of 4-PCH, estimate the 4-PCH concentrations of both offices in ppm or ppb unit. Consider two ventilation cases: one complying ASHRAE Standard 62.1 Ventilation Rate Procedure (VRP) and the other is 30% more than VRP to comply LEED v.4 BD&C EQ credit "Enhanced Indoor Air Quality Strategies".

2. Evaluate the effect of "flush-out" option of LEED v4 BD&C EQ credit "Indoor Air Quality Assessment" Option 1-Flush Out using IA-Quest for an office space:

- Size: 15 m × 20 m × 3.2 m
- Number of occupants: 25
- Occupancy hours: 08:00 - 18:00, 7 days a week
- Outdoor air ventilation rate

• Flush out period: 500 liter/sec
• After occupancy: minimum ventilation rate set by ASHRAE Standard 62.1 VRP

- Window & door area : 40 m2
- Office finishing materials

• Wall-to-wall carpet with adhesive on concrete slab (Crp7a)
• Latex paint (PT7) on plain gypsum board (GB1) for all wall finishing except window & door area
• Cellulose acoustical ceiling tiles (ACT3)

- Considered contaminants: toluene and TVOC

• Toluene: initial room concentration 0.2 mg/m3; outdoor air concentration 0.01 mg/m3
• TVOC: initial room concentration 2.0 mg/m3; outdoor air concentration 0.1 mg/3

Simulate the following three cases for 60 days and

(a) Draw two figures (one for toluene and the other for TVOC) comparing the concentration profiles (Concentration vs. time curves) of three cases.

(b) Determine the highest & the lowest TVOC concentrations during occupancy for each case on the day 30, 40, 50 & 60. Compare with toluene and TVOC concentration limits set in LEED v4 BD&C EQ Credit "Indoor Air Quality Assessment" Option 2-Air Testing.

(c) Examine the simulation results of three cases and discuss the limitations of IA-Quest.

Case 1: Flush-out path 1

(a) The space is ventilated constantly at 500 liter/sec of outdoor air for flush-out until the total 4,267,140 liters of outdoor air per square meter of gross floor area is delivered

(b) After the flush-out period, the building is occupied and regular ventilation schedule is applied:

o 07:00 - 18:00 period with the ventilation rate equals to the minimum requirement of ASHRAE 62.1 VRP
o Overnight the ventilation system is turned off.

Case 2: Flush-out path 2

(a) The space is ventilated constantly at 500 liter/s of outdoor air for flush-out before occupancy until 1,066,260 liters of outdoor air per square meter of gross floor area is delivered.

(b) Then, the building is occupied, and the flush-out is continued following the Path 2 until total (including pre-occupancy flush-out) 4,267,140 liters of outdoor air per square meter of gross floor area is delivered:

o 05:00 - 18:00 period with 500 liter/sec
o Overnight the ventilation system is turned off.

(c) Once the flush-out is finished, the regular ventilation schedule is applied:

o 07:00 - 18:00 period with the ventilation rate equals to the minimum requirement of ASHRAE 62.1 VRP
o Overnight the ventilation system is turned off.

Case 3: No flush-out

The building is ventilated using the regular ventilation schedule:

o 07:00 - 18:00 period with the ventilation rate equals to the minimum requirement of ASHRAE 62.1 VRP
o Overnight the ventilation system is turned off.

Attachment:- Assignment.pdf

Reference no: EM131406383

Questions Cloud

Prepare a comprehensive table of the process capabilities : On the basis of the data developed in Problem 24.54, describe your thoughts regarding the procedure to be followed in determining what type of machine tool to select when machining a particular part.
Which elements of total compensation would be more important : If you were considering a job offer, which elements of total compensation would be more important to you: base pay, incentives, or benefits and services? Why? What are the implications of your answer for employers seeking to attract people like yo..
Permission to make changes to the file : Show the command you would use to give the people in your group permission to make changes to the file.
Find the machining time and metal-removal rate : If the feed per tooth is 0.2 mm/tooth and the cutting speed is 0.75 m/s, find the machining time and metal-removal rate for removing 6 mm from the surface of the part.
Determine the emission rates of each carpet : BLDG 475/6751- Using the mass balance equation, determine the emission rates of each carpet. After occupancy: minimum ventilation rate set by ASHRAE Standard 62.1 VRP
Dynamic and interactive websites : In addition to HTML, what languages should a developer be able to use (through knowledge or through tools) in order to create dynamic and interactive websites? Explain why you included each language in your list.
Assess the challenges of managers providing accurate : Assess the challenges of managers providing accurate, timely, and effective feedback to employees. Recommend how managers can overcome any two (2) of the challenges you identified. Of the concepts covered in the textbook chapter, determine which,..
Calculate the power required : Assume that in the face-milling operation shown in Fig. 24.6 the workpiece dimensions are 100 mm by 250 mm. The cutter is 150 mm in diameter, has eight teeth, and rotates at 300 rpm
Software project cost estimation techniques : One of the most difficult tasks in software development is cost estimation. Software development projects are resource intensive and most of the cost is in labor. Cost estimates are therefore mostly comprised of time estimates. There is a lot of v..

Reviews

Write a Review

Other Subject Questions & Answers

  Global perspective issues

How does the psychologist Tetlock explain the outrage of American college students at the thought that adoption agencies should place children with couples willing to pay the most?

  Establishing security and control.

Establishing security and control. Be sure to specifically address considerations for assessing the possible exposure to biological or chemical toxins.

  How can understanding more about your learning style and

this assignment will assist you in identifying your learning style and creating your learning strategies.

  Explain how a functionalist and conflict theorist

Using your understanding of theory and the chart on page 17 of your textbook, explain how a functionalist, conflict theorist, and interactionist would explain the Affordable Care Act. Be sure to discuss the ACA in terms of each perspective's view ..

  Determine a suitable research goal

Determine a suitable research goal. Discuss what type of sampling could be used for this study. Identify which types of research designs above (from Part I) would be most appropriate to use. State your hypothesis of the expected results for this prop..

  Did you identify with people and situations in the selection

Did you identify with the people and situations in the selection? How? If not, how do you engage differently in interpersonal communication in similar situations to the ones described and analyzed?

  Evaluate and describe current research in these perspectives

Assess the types of personality measurements and research designs used in in the peer-reviewed articles you researched. Briefly describe the main theoretical models represented within each of the perspectives of personality and explain the commona..

  How well you explain the mental process being reviewed

Your structured external assignment will be grade on the following criteria: How well you explain the mental process being reviewed and How well you apply the mental process to the selected problem

  How a juvenile can be transferred to adult court

Write a 750 - 1000 word, APA style paper, discussing how a juvenile can be transferred to adult court.

  International trade brings benefits-intensifies inequities

International trade brings benefits but also intensifies inequities.

  Describe the precautionary measures taken by airlines

Analyze the fundamental differences between Shi'ites and Sunnis in relation to the war on terrorism. Describe the precautionary measures taken by airlines to prepare for probable issues before they arise.

  How could the doctor-patient relationship be explored

After viewing the entire video, respond with a brief summary of his ideas about patient care (3-5 sentences), and finally, how could the doctor-patient relationship be explored as a potential research topic

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd