Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 400-V three-phase, wye-connected synchronous motor delivers 12 hp at the shaft and operates at 0.866 lagging power factor. The total iron, friction, and field copper losses are 1200 W. If the armature resistance is 0.75ohm per phase, determine the efficiency of the motor.
Compute the first 10 samples of the step response for the nonrecursive difference equation: y(n) = x(n) -0.5x[n-1]-0.7x[n-2] Indentify which of the following filters are recursive and which are nonrecursive.
A modulating signal is amplified by a 80% efficiency amplifier before being combined with a 20 kW carrier to generate an AM signal. what would be The required DC input power to the amplifier, for the system to operate at 100% modulation.
A message signal, x(t) has a bandwidth of 15 kHz and an average power of 0.5 W. This signal is to be uniformly quantized with an input range of range of +-5 V. What is the bit rate of the corresponding PCM signal if the SQNR is to be greater than ..
The input of a lightly loaded transmission gate is slowly Ajit Pal, IIT Kharagpur Ajit Pal, IIT Kharagpur changes from HIGH level to LOW level. How the currents through the two transistors vary
A silicon diode has a reverse current of 5 uA and 25 degrees celcius and 100uA at 100 degrees celcius. What is the saturation current and surface leakage current at 25 degrees celcius
Looking at feedback and some Opamp problems, If the unity gain frequency is 5 MHz and the midband open-loop voltage gain is 200,000, what is the cutoff frequency?
Create a bandpass filter with cutoff frequencies of 100-1k, attenuate by at least 3db at desired frequency(100-1k) and at 60Hz attenuate by 10 db. Resistor, Capacitor, Inductor, and Op-amps can be used.
A spread-spectrum acquisition system uses a serial search scheme.The synchroniser integrates the squarer output for interval of 0.1s and the synchroniser output is sampled at intervals of 0.05s . The probability of false alarm is 0.064255 .
How the inversion voltage is affected by the relative sizes of the sizes of the nMOS nMOS and pMOS TRANSISTORS OF THE CMOS transistors of the CMOS inverter
Derive the expression for TRANSFER FUNCTION and write the expression for magnitude and phase of H(f).
For a chip area with area 2cm x 2cm in a 180nm logic technology, what is the approximate area of the same chip when ported to a 32nm logic technology.
The maximum flux density in the core of a 250/ 3000 volts, 50 Hz single phase transformer is 1.2 Wb/m2. if the emf per turn is 8 volt, determine (i) primary nad secondary turns (ii) area of the core
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd