Determine the displacement of the beam at each end

Assignment Help Civil Engineering
Reference no: EM13560390

1.A rigid beam (AB), 12 feet in length, with a point load of 9 kips (4 feet from A) is resting on two short steel rods (AC & BD). Diameter of Rod AC is 1 inch, Rod BD diameter is 2 inches. Assuming no buckling in rods, Determine the displacement of the beam at each end.

2.Find the length and width of a square basin for virus disinfection of a flow of 6 MGD. You may assume a depth of 5 ft, a C(dot)t product of 10 (mg/L) (dot)min for 1.5-log removal, and a target free chlorine residual of 0.6 mg/L.

Reference no: EM13560390

Questions Cloud

Apply the concepts and techniques of the module : The purpose of the Final Project is to apply the concepts and techniques of the module to the analysis of real-world situations or problems. You will be expected to use diverse sources of information and to carry out an original analysis rather than ..
Determine the discharge along the gutter and calculate : Someone spills a container of gasoline at the farthest corner of the parking lot during the storm. Estimate the average time for the gasoline to reach the outlet of the gutter.
The situation analysis is essentially a process : The situation analysis is essentially a process of assessing the current situation facing the organisation, arriving at a set of assumptions about the future and identifying key strategic issues that are likely to confront the organisation". Based st..
Design a non-air-entrained concrete mix for a small job with : Design a non-air-entrained concrete mix for a small job with a maximum gravel size of 3/4". Show the results as follows:
Determine the displacement of the beam at each end : A rigid beam (AB), 12 feet in length, with a point load of 9 kips (4 feet from A) is resting on two short steel rods (AC & BD). Diameter of Rod AC is 1 inch, Rod BD diameter is 2 inches. Assuming no buckling in rods, Determine the displacement of the..
What are the strategic aims of the company : What are the strategic aims of the company?
Explaining what corporate social responsibility : Explaining what Corporate Social Responsibility
Determine the minimum horizontal force necessary for 200 lb : Determine the minimum horizontal force necessary for 200 lb man to scale crevice (using his feet and back). The coefficient of static friction between his shoes and his back against the wall is 0.4.
What is the total volume of runoff : It rains 3.0 in. on a 20.0 acre watershed. What is the volume of rainfall excess if 30% of the watershed area is a lake and infiltration on the soil is estimated at 1.0 in? What is the total volume of runoff? Express your answer in cubic feet.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Concentration of tracer in the reactor

What is the concentration of tracer in the reactor 1 h after tracer addition is terminated? The reactor had an initial concentration of tracer of 1.0 mg/L when tracer addition commenced.

  What is the lenght of the critical exterior flaw in the bar

A hot-rolled 7-mm-diameter steel rod is axially loaded at room Temp under a fully reversed cyclic loading. under the rotating beam test, the endurance limit for this steel is 470 MPA, under static loading the ultimate strenght is 1200 MPA.

  What is the equilibrium droplet size at a relative humidity

What is the equilibrium droplet size at a relative humidity of 100% for a NaCl cubic crystal 0.077 micron on a side

  Determine the magnitude of the velocity of the collar

The undeformed length of the spring is l. Knowing that the collar is released from rest at x = and neglecting friction between the collar and the horizontal rod, determine the magnitude of the velocity of the collar as it passes through point C.

  What distance do move in 3 sec and what is tension in cord

Body A and body B are connected by an inextensible cord. If both bodies are released simultaneously from rest, what distance do they move in 3 sec and what is the tension in the cord. The weight of A is 50 lb and the weight of B is 10 lb.

  While the head surveyorheld .62 ft. what is the distance

Using Fy=50ksi, select the lightest available section for the spanand loading shown. Consider moment and shear only and neglect beamweight in all calculations. The member is assumed to have fulllateral bracing.

  Find h max water depth that will alow car to pass

Listed on cramster as ask. There is a car driving through water. Velocity is 12mph. Find h (max water depth) that will alow car to pass. List all assumption and calculations is the problem statement.

  Magnitudes of fac and fad

The 70 m tall tower is supported by three cables that exert forces FAB, FAC, and FAD on it. The magnitude of the force FAB is 2 kN. The x and z components of the vector sum of the forces exerted on the tower by the three cables are zero. What are ..

  Determine the net work produced each time this cycle

An ideal Sterling cycle operates between thermal energy reservoirs at 27 degrees C and 527 degrees C. The maximum cycle pressure is 2000 kPa. Determine the net work produced each time this cycle is executed, and the cycle's thermal efficiency

  Calculate the base width of channel

The ladder AB weighs 10 N and leans against a wall as shown. Assuming that the coefficient of static friction µs is the same at A and B, determine the smallest value of µs for which equilibrium is maintained. The weight force acts at the center of th..

  What will be the approximate temperature of the alloy

Is it possible to have a copper-silver alloy of composition 50 wt% Ag-50 wt% Cu that at equilibrium, consists of α and β phases having mass fractions Wα = 0.60 and Wβ=0.40

  Find what is the ratio of the flow rates in the two pipes

Two pipes of identical length and material are connected in parallel. The diameter of one is twice the diameter of the other. What is the ratio of the flow rates (Q2/Q1) in the two pipes

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd