Determine the direction of the resultant force measured

Reference no: EM13562653

1.If F_1=470N and theta=26 degrees, determine the magnitude of the resultant force of the three forces acting on ring A.

Determine the direction of the resultant force measured counterclockwise from the positive x-axis.

2.The driver of a car traveling up a 2% grade at an initial speed of Vo applied the brakes abruptly and the vehicle slid to a complete stop at an average deceleration of 8ft/s^s. Was the pavement wet or dry?

Reference no: EM13562653

Questions Cloud

What will its length be if a force of 420lbs is applied : Water at 68 degrees f is in a long, rigid cylinder of inside diameter 0.600 in. A plunger applies pressure to the water. If, with zero force, the initial length of the water column is 25.00 in, what will it's length be if a force of 420lbs is applied..

Atrazine is an herbicide widely used for corn and : Atrazine is an herbicide widely used for corn and is a common groundwater pollutant in the corn-producing regions of the United States. The log Kow for atrazine is 2.65. A typical application rate is 0.25 g/m2.

What is the vial radius of curvature : With the bubble centered, a 100-m length sight gives a reading of 1.352 m. After moving the bubble four divisions off center, the reading is 1.410 m. For 2-mm vial divisions

What is the velocity of an electron that falls through : What is the velocity of an electron that falls through a magnetic field aligned electric potential of volts across an accelertion region that is 10 k long? (neglect collisions and gravity and assume the electron has zero degree pitch-angle (i.s movin..

Determine the direction of the resultant force measured : The driver of a car traveling up a 2% grade at an initial speed of Vo applied the brakes abruptly and the vehicle slid to a complete stop at an average deceleration of 8ft/s^s. Was the pavement wet or dry?

Determine the normal strain in each bar : The two bars shown in the figure are used to support a load P. When unloaded, joint B has coordinates (0, 0). After load P is applied, joint B moves to the coordinate position (0.35 in., -0.60 in.). Assume a = 11 ft, b = 6 ft, and h = 8 ft. Determine..

How much work must be done to move a chair : How much work must be done to move a 3.8 kg chair 6.1 m acrossthe floor at constant velocity if the coefficient of kineticfriction between the chair and the floor is 0.64

Will water bubble into the vapor phase under these : A student in the laboratory plans to exert a vacuum in the head space above a surface of water in a closed tank. She plans for the the absolute pressure in the tank to be 10,400 Pa. The temperature in the lab is 20°C. Will water bubble into the vapor..

What is the maximum amount of cargo : A small truck is to be driven down a 4% grade at 70mi/hr. The coefficient of road adhesion is 0.95, and it is known that the baking efficiency is 80% when the truck is empty and decreases by one percentage point for every 100 lb of cargo added. Ignor..

User Account

All Pages