User Account

All Pages

Determine the differential settlement between centre line

Assignment Help Civil Engineering
Reference no: EM132416566

A building is to be constructed with a ring beam foundation on a site where the soil profile consists of 2m of clay with an over-consolidation ratio of 4 overlying a 7m thick layer with an over-consolidation ratio of 2, which overlies rock. The soil properties are Cc = 0.3, Cr = 0.08 and gsat = 20 kN/m3 for both clays, and the water table is 1 m below the soil surface. Determine the settlements when a stress of 100 kPa is applied by the building. Determine the differential settlement between the centre line of the ring beam and under the centre of beam. The inner and outer radii of the ring beam are 8m and 12m respectively.

Reference no: EM132416566

Questions Cloud

Halogen systems for extinguishing fires : Server rooms often have halogen systems for extinguishing fires. An accidental discharge of the halogen could have disastrous results.
Calculate the wet density in pounds per cubic feet : A gray silty clay (CL) is sampled from a depth of 12.5 feet.The "moist"soil was extruded from a 6-inch-high brass liner with an inside diameter of 2.83 inches
Estimate the wet density-dry density : Estimate the wet density, dry density, buoyant density, porosity, and void ratio. Clearly state any necessary assumptions.
Discussing the possession and carrying of firearms : Please write a one to two page paper discussing whether or not the possession and carrying of firearms or the illegal purchase of a firearm are "victimless".
Determine the differential settlement between centre line : Determine the differential settlement between the centre line of the ring beam and under the centre of beam.
What the threat level means to the emergency responders : The Reading in this unit discusses the Homeland Security Advisory System (HSAS) created by Homeland Security Presidential Directive 3. The HSAS was a threat.
Student associated perception-reaction time : If the student was traveling at 90 kph when the sign was first spotted, what was the student's associated perception-reaction time?
Governments health information technology initiatives : Discuss the governments health information technology (HIT) initiatives that have led to integrated PM/EHR Programs.
Describe contemporary substance abuse strategies : Describe contemporary substance abuse and addiction treatment strategies. Compare treatment strategies for various correctional facilities.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the optimal amount of space rays and zappers

Galaxy Industries is a manufacturing company that produces two toy doll models: the Space Ray and the Zapper. The Space Ray can be sold for a profit of $8/dozen and a profit of $5 can be made if a dozen of Zappers are sold.

  Calculate the elevation at the profile grade line

Given the same data as problem 7 calculate the elevation at the profile grade line at 242+00 and then project a grade to 29 ft right using a -2% cross slope

  Find the x maximum distance

This is a projectile motion when the initial angle is 30 degrees and initial velocity s 10 m/s. Find the total travel time. Find the x maximum distance.

  Calculate the radius of curvature

A bimetallic strip is constructed of strips of yellow brass and Invar bonded together at 30?C. Each has a thickness of 0.3 mm. Calculate the radius of curvature when a 6.0-cm strip is subjected to a temperature of 100?C.

  Draw the shear and moment diagrams for the cantilever beam

Draw the shear and moment diagrams for the cantilever beam shown in the figure below. Label all values and units clearly and show all work when calculating shear forces and moments.

  How much would end of wing deflect relative to fuselage

If the aluminum wing has an I of 745 in^4 and aluminum has an E of 10.1 *10^6 psi, how much would the end of the wing deflect relative to the fuselage of the aircraft compared to the position it has when aircraft is on the ground.

  Find the air-fuel ratio on a mass basis

The gas-turbine cycle in Problem 10.28 has qH = 960 kJ/kg air added by combustion. Assume the fuel is methane gas and qH is from the heating value at T0. Find the air-fuel ratio on a mass basis.

  Determine the velocity v when the acceleration is 3 m/s2

The position s of a particle along a straight line is given by where s is in meters and t is the time in seconds. Determine the velocity v when the acceleration is 3 m/s2

  Depth of the sedimentation tank

A drinking water treatment plant will be designed to process a flow of 15,000 m3/d. The sedimentation tank will have a residence (detention) time of 4 hours and the overflow rate (Q/A) of 16 m 3 /m 2 -day. Estimate the required surface area (A), an..

  Determine the instantaneous center of rotation of the spool

Knowing that end B of the tape is pulled downward witha velocity of 300 mm/s and that at the instant of the total thickness of the tape on the spool is 20 mm, determine (a) the instantaneous center of rotation of the spool,

  What is the retention time of the house

What is the steady-state concentration of radon in the house? Express your answer in units of pCi/L.

  Characteristics of concrete construction

Question 1: Discuss the characteristics of concrete construction for very tall buildings.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd