Determine the design load for strength and serviceability

Assignment Help Civil Engineering

Reference no: EM13545630

Determine the design load for strength and serviceability limit states (short-term and long term), for a steel beam in a residential building with the following data;

Live load combination factor for strength 0.4

Live load combination factor for serviceability, short term 0.7, long term 0.4

(a)Beam is 310 UB 40, centre to centre spacing of beam is 3metres

(b) Slab supported by beam is 150mm thick reinforced concrete.

Reference no: EM13545630

Questions Cloud

What happens after the memory is full : Assuming approximately 19,296 data points can be held in memory, with a 21X Datalogger (CR23X Micrologger), capturing battery voltage; panel temperature

Compute the maximum fiber stress : An S 12x40.8 of A36 steel in a building is supported as a simple beam having a span equal to 17ft 6in. and carries a uniform load equal to 1.60 klf, which includes the weight of the beam over the entire span.

What is the probability that the probability if the flow : You are provided that a 33-year record of peak annual flow rates was subjected to a frequency analysis. You are interested in the median value. Thus, for part (a), what is the probability that the probability if the flow rate exceeds the median value..

Determine the elongation of the cable elongation : A homogeneus cable of a lenght L and uniform cross section is suspended from one end. A. denoting by p the density (mass per unit volume) of the cable and by e its modulus of elasticity. determine the elongation of the cable

Determine the design load for strength and serviceability : Determine the design load for strength and serviceability limit states (short-term and long term), for a steel beam in a residential building with the following data;

Determine the runoff rate from a two storm system if the : Determine the runoff rate at t = 15.0 hr from a two storm system if the first storm drops 2.0-inches starting at t = 0, and the second storm drops 5.0-incheds starting at t = 12.0 hrs.

Compute the unit weight dry unit weight degree of saturation : Find the live load capacity, Pl of a beam with f prime c=4 ksi, fy=60 ksi, Wd=self weight, beam width b=18 inches, beam height h=24 inches, effective depth=21 inches, concrete unit weight=150 pcf, steel As=3-#9 bars.

Calculate the respective thickness of the soild phase : An investigation of a particular site revealed a 4m thick deposit of peat overlying a deposit of soft clay .A 150 mm diameter by 300 mm long sample taken from the peat deposit was weighed and found to have a total mass of 5036 g and after oven-drying..

Compute the work done by the gas for constant pressure : Two pounds of an ideal gas are contained within a piston-cylinder arrangement. The initial volume and pressure are 1 ft3 and 75 psia respectively. The final volume is 3 ft3.

User Account

All Pages