Determine the depth that will result upstream during design

Reference no: EM13298950

A 1.5-m diameter culver( concrete barrel, well - rounded entrance) that is 20m long is installed on a slope of 2 percent. The design discharge is 9.5 m^3/sec and the inlet will be submerged but not the outlet. Determine the depth that will result upstream (above the invert) during the design flood event.

Reference no: EM13298950

Questions Cloud

Determine how much area must the heat exchanger have : You have been assigned to design a heat exchanger to cool a gaseous process stream in a chemical plant. The stream flow at 20 kg/s and enters at 431 oK, It has a heat capacity of 3.45 J/g-oC , and needs to be cooled to 402 oK.

How much should a pack of cigarettes cost : How much should a pack of cigarettes cost?

Local performers are gradually loosing in the competition : Local performers are gradually loosing in the competition with recognized international bands, and Serida’s income decreases to $50 while prices are the same as before. What is the equation of this new budget line? How does it compare to the budget l..

Determine itc percentage change in earnings : Suppose that ITC's degree of combined leverage (DCL) is 3.00 at a sales volume of $9 million. Determine ITC's percentage change in earnings per share (EPS) if forecasted sales increase by 20 percent to $10,800,000.

Determine the depth that will result upstream during design : The design discharge is 9.5 m^3/sec and the inlet will be submerged but not the outlet. Determine the depth that will result upstream (above the invert) during the design flood event.

What is the firms fixed cost : Suppose that the total short-run cost function of a firm is given by TC = 200 + 20Q, where TC is the total cost and Q is the total quantity of output.

Determine the length of the hydraulic jump and energy loss : A spillway carries a discharge of 22.5 m^3/sec with the outlet velocity of 15 m/sec at a depth of 0.2m. Select an adequate USBR stilling basin and determine the sequent depth, the length of the hydraulic jump and energy loss.

Explain solvents in order of increasing polarity and acetone : Rank the following solvents in order of increasing polarity: Acetone, Petroleum ether, methanol, ethanol, dichloromethane

Find elevation difference in siphon crown nd downstream pool : The siphon crown is 1.2m above the water surface elevation of the reservoir and a length of 10m away from the siphon entrance. If the siphon diameter is 30 cm, the friction factor is 0.2, and the head loss coefficients are 0.2 inlet and 0.1 exit,

User Account

All Pages