Determine the current in the first resistor

Reference no: EM13709258

Compute all parts of given question:

Question: Two resistors, 62.0 ohms and 54.0 ohms, are connected in parallel. The current through the second resistor is 2.00 A.

Part A: Determine the current in the first resistor?

Part B: What is the total power supplied to the two resistors?

I need help to find the total power supplied to the two resistors.

Reference no: EM13709258

Questions Cloud

How much farther does the car travel : Alcohol consumption slows people\'s reaction times. In a controlled government test, it takes a certain driver 0.39 s to hit the brakes in a crisis when unimpaired and 1.19 s when drunk. how much farther does the car travel

Calculate the heat transfer rate from the fin : A circumferential fin of cross section, 3.7 cm-OD and 0.3 cm-thick surrounds a 2.5 cm-diameter tube. The fin is constructed of mild steel. Air blowing over the fin produces a heat transfer coefficient of 28.4 W/(m2.K). If the temperature of the fin a..

Final temperature of the steam and the volume of the vessel : An insulated vessel has two compartments separated by a membrane. On one side is 1 kg of steam at 400 oC and 200 bar. The other side is evacuated. The membrane ruptures filling the entire volume. The final pressure is 100 bar. Determine the final tem..

What is the total time the train takes to make : A train leaves the station on a 45 km commute. The train must make a 60.0 sec stop every 0.90 km to pick up and drop of passengers. What is the total time the train takes to make the entire commute

Determine the current in the first resistor : Two resistors, 62.0 ohms and 54.0 ohms, are connected in parallel. The current through the second resistor is 2.00 A. Determine the current in the first resistor

The rate of heat flow at the root of the blade : A turbine blade 6.3 cm long with cross-sectional area A 4.6 x 10-4 m2 and perimeter P 0.12 m, is made of stainless steel (k =18 W/m K). The temperature of the root, Ts, is 482°C. The blade is exposed to a hot gas at 871°C and the heat transfer coeffi..

Compute drag produced by the airfoil : The figure on the right shows an approximated pressure distribution on an airfoil and the direction of incoming flow. Alpha is 10 degrees, the pressure distribution on the top is 3n/m and on the bottom is 1n/m. The chord Length is 1 meter.

Use the constant specific heats at room temperature : An air-standard dual cycle has a compression ratio of 18.2 and a cut off ratio of 1.31. The pressure ratio during constant volume heat addition process is 1.5. At the beginning of the compression, P1=80 kPa, T1 = 20°C at the beginning of the cycle. U..

Calculate the uncertainty in the dimensional measurement : A pneumatic displacement gage has d1=0.762 mm and d2=1.575 mm. The supply pressure is 68919.7 Pa with a random fluctuation of ±483 Pa, and the differential pressure Pd-Pa is measured with a water manometer that may be read with an uncertainty of 12.4..

User Account

All Pages