Determine the cost per kilowatt hour for the energy

Assignment Help Electrical Engineering
Reference no: EM13227147

Determine the cost per kilowatt hour for the energy delivered by a typical alkaline 9-V "transistor" battery that costs $1.95 and is capable of delivering a current of 50 mA for a period of 10 hours. (For comparison, the approximate cost of energy purchased from electric utilities in the United States is $0.12 per kilowatt hour.)

Reference no: EM13227147

Questions Cloud

Find the voltage across the inductor for an instance : 1- Find the voltage across the inductor for t > 0 2- Sketch the voltage and the current as a function of time 3- Find the power ( in microwatts) at the terminals of the inductor when t = 200 ms
Calculate the ph of the solutions of mercaptoacetic acid : Consider the diprotic acid mercaptoacetic acid, where the fully protonated form can be denoted by H2A. Calculate the pH of the solutions below.
Determine the networks equivalent resistance : A network connected between terminals a and b consists of two parallel combinations that are in series. The first parallel combination is composed of a 10-phm resistor and a 15-ohm resistor. The second parallel combination is composed.
Explain what kind of standard is y : A solution containing an unknown amount of X and 10.25 mM of Y was run and gave peak areas of 8.20 and 6.50 cm2 respectively. What is the concentration of X in the unknown solution? What kind of standard is Y?
Determine the cost per kilowatt hour for the energy : Determine the cost per kilowatt hour for the energy delivered by a typical alkaline 9-V "transistor" battery that costs $1.95 and is capable of delivering a current of 50 mA for a period of 10 hours. (For comparison, the approximate cost of energy..
Compute the molar mass of the unknown gas : Calculate the molar mass of the unknown gas. (Remember that the faster the rate of effusion, the shorter the time required for effusion of 1.0 L; that is, rate and time are inversely proportional.)
How much charge must move through the battery : A certain battery has terminals labeled a and b. The battery voltage is vab = 12 V. a) To increase the chemical energy stored in the battery by 600J, how much charge must move through the battery
Why does the electron gain or lose energy : The charge carried by an electron is ?1.60×10?19 C. Suppose that an electron moves through a voltage of 120V from the negative polarity to the positive polarity. How much energy is transferred Does the electron gain or lose energy
Define what is the partial pressure of each component : A mixture of gases contains 2.89 g of N2, 5.38 g of H2, and 9.00 g of NH3. If the total pressure of the mixture is 2.24 atm, what is the partial pressure of each component?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How much energy is required to increase diameter of water

1- If the diameter of a spherical water droplet is 100.0 µm, how much energy is required to increase the diameter of the water droplet by 3.0 µm The surface tension of water is 1.0 x 10-3 J/m2. 2- A metal crystallizes in a face-centered cubic lat..

  Find the complex power of the other load

two loads connected in parallel are supplied from a single phase 240v rms source. the two loads draw a total real power of 400 kw at a power factor of 0.8 lagging. one of the loads draws 120 kw at a power factor of 0.96 leading.

  What is the maximum frequency that an input

An OpAMP has a unity gain frequency (ft) of 10MHz and a slew rate of 10V/us and AVoc = 120dB at DC (f=0).  Assume VCC = -VEE = 15 Volts.a. Approximate the cutoff frequency of the OPAMP itself. b.

  Define the problem on rankine cycle

Water is the working fluid in a vapor power cycle with reheat, superheat and reheat. Superheated steam enters the first turbine stage at 8 MPa, 480 C and expands to 0.7 MPa

  Determine and represent the signal

Fourier transform X(w)=Xreal(w)+j(Xi(w)). Determine and represent the signal y(w) that gives the fourier transform of Y(w)=Xi(w)+Xreal(w)e^exp(j2w).

  What is the blocking probability of the system

What is the blocking probability of the system in (b) when the maximum number of users are available in the user pool?

  Explain very useful not only in obtaining the rectangular

very useful not only in obtaining the rectangular and polar forms of complex numbers

  Finding out the op level from an attenuator of know ip

Determining the o/p level from an attenuator of know i/p, An attenuator has an attenuation of 10 dB over the frequency range 10 MHz to 1.0 GHz

  What is the maximum number of consecutive bits

What is the maximum number of consecutive bits that are in error for a transmission through this channel if the data rate is 10Kbps? If the data rate is 11 Mbps?

  Explain finding rms current through capacitor and inductor

Finding rms current through Capacitor and Inductor, A circuit consists of a sine wave signal generator and a reactive component (L or C). The output of the generator is a sine wave with a peak amplitude of 8.8 volts at a frequency of 10.0 kHz.

  Explain hspice netlist example

Hspice Netlist example, Often Netlist is generated by programs such as Cadence. However, on the rare occasions when one has to look at Hspice netlist

  What is the requirement for the phase response transfer

What is the requirement for the phase response (transfer function) of each of these links to avoid distortion of the transmitted waveform?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd