Determine the correct horizontal distance considering

Assignment Help Civil Engineering
Reference no: EM13542302

A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long. The difference in elevation between the initial and the end point was found to be 1.25 m. The 30-m tape is of standard length at a temperature of 10ºC and a pull of 5 kg. During measurement the temperature reading was 15ºC and the tape was supported at both ends with an applied pull of 7.5 kg. The cross-sectional area of the tape is 0.065 cm2 and E = 2.0 x 106 kg/cm2. The tape weighs 0.075 kg/m and has a linear expansion is 0.0000116 / ºC. Apply corrections for temperature, pull, and sag to determine the correct horizontal distance considering a gentle slope.

Reference no: EM13542302

Questions Cloud

Describe how edge dislocations move under an applied : In the context of JCT 2005, to what extent can a subcontractor negligently set fire to an existing building with impunity?
When the pressure in the tank reaches the valve is closed : Steam at 800 kPa and 300 C is bled off from a large supply line, passed through a valve, and allowed to enter an initially evacuated, uninsulated tank with a volume of 0.3 m3.
Apply corrections for temperature pull and sag to determine : What is the water content and liquidity index of the fines in compacted mass?A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long.
Calculate the linear density of atoms in these directions : For FCC diamond cubic structures, give the lattice coordinates for the atoms found in the [100], [110], [111] direction? and Calculate the linear density of atoms in these directions for Ge.
Determine the correct horizontal distance considering : A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long. The difference in elevation between the initial and the end point was found to be 1.25 m
Draw the influence line for the shear at point b : Draw the influence line for the shear at point B. Plot numerical values every 5 ft. Assume the support at A is a roller and C is fixed. EI is constant.
Determine the shear force and bending moment diagrams : A wood mallet has a cylindrical head 6 inches long and 3 inches in diameter. If the cylindrical head is 1 inch in diameter how long must it be for the mallet to balance at a point 6 inches from where the handle enters the mallet? (use 40 lb / ft cube..
What rate of perspiration would be needed to maintain a : Considere a person who consumes 2100 kcal par day, of which 2000 kcal is converted thermal energy.( the remaining 100 kcal is used to do work on the environment.) The person has a surface area of 1.8 m² and is dressed in a bathing suit.
Should the company proceed with the process change : The company Eco-Safe is adding pollution control equipment to its process and reducing emission of pollutants. The annual waste disposal cost of the current process is $130,000 and the annual operating cost is $600,000

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the average normal stress and average shear stress

A wood board with a 2in. by 4in. cross section is subjected to a tensile load of 100 lb. Determine the average normal stress and average shear stress developed in the wood fibers that are oriented at 30 degrees with the axis of the board.

  What is the angle of inclination of the plane

A body slides down a frictionless plane and during the third second after starting from rest if it travels 20.4m. What is the angle of inclination of the plane?

  Calculate the work done and heat transfer

Tank A has a volume of 100 liters and contains saturated vapor r-134 at 30C. With the valve open slightly flow enters cylinder B. a pressure of 200kpa is required to lift piston in b. the process ends when the pressue at A drops to 200kPa.

  Determine the distance corrected for sag with a tension

A distance of 72.55 ft is recorded using a steel tape weighing 0.016 lb per foot. The tapes is supported only at the ends with a tension of 15 lb. Find the distance corrected for sag.

  Determine what is the probability that the system operates

Consider a system that consists of 4 devices. The probabilities of failure for each of the devices are, respectively: 10%, 25%, 20%, and 30%. (a) If these components were in series, what is the probability that the system operates

  Determine the largest magnitude of the force at a

the cantilevered wild- flange steel beam is subjected to the concentrated force P at its end. Determine the largest magnitude of this force so that the bending stress developed at A does not exceed 180 MPa.

  How long does it take to reach an altitude of 3000m

Missiles designed for defense against ballistic missiles haveattained accelerations in excess of 100g's or 100 times theacceleration due to gravity. Suppose that the missile

  What is nominal yearly interest rate on a loan with interest

what is the nominal yearly interest rate on a loan with quarterly interest of 3% with quarterly compounding

  Compute the detention time in the aerated unit

A separate hopper-bottomed grit storage tank has a usable volume of 3 cubic yards. Compute the detention time in the aerated unit and the estimated length of time required to fill the storage tank with grit.

  Find what must be the rated horsepower of the motor

What would be the resistance on a level road. What horsepower must be delivered to the wheels on the grade? If the efficiency is 80%, what must be the rated horsepower of the motor.

  What dilution rate would be required to control the do sag

At a plant making MSG (monosodium glutamate) for use inAsian cooking the waste stream discharged to a nearby streamcontains 100 mg of glutamic acid(C5H9O4N) per liter.

  Formulate problem as an ip and find optimal solution

The Record-a-Song company has contracted with a rising star to record eight songs. The sizes in MB of the different songs are 8, 3, 5, 5, 9, 6, 7, and 12, respectively. Record-a-Song uses two CDs for recording. Each CD has a capacity of 30 MB.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd