Determine the cop of the heat pump and rate

Assignment Help Civil Engineering
Reference no: EM13545642

Refrigerant 134a enters the condenser of a residential heat pump at 800 kPa and 35 degrees celcius at a rate of 0.018 kg/s and leaves at 800 kPa as a saturated liquid. If the compressor consumes 1.2 kW of power, determine a) the COP of the heat pump and

b) the rate of heat absorption for the outside air.

Reference no: EM13545642

Questions Cloud

Which compressor should he buy and why : A diver is planning to salvage a Spanish galleon located in 200 feet of water. He plans to use a diving suit that will be supplied with air from a hose (assume this to be amply sized) connected to a compressor that he will locate in his boat on the s..
When the pump operates the measured power draw is equivalent : A pump for a wastewater treatment plant has a motor with a nameplate rating of 20 HP. When the pump operates the measured power draw is equivalent to 15 HP. The pump operates 80% of the time.
At what ocean level h will the gate first open : When using an automatic level and rod to conduct differential leveling for construction grade control of a concrete wall, the first necessary step following set up of the level is to:
The only section remaining to be installed is a segment : A town is installing a new 10” main to carry drinking water. The only section remaining to be installed is a segment through the middle of town. However, the excavators discover an archaeological site. The town decides to split the main into two sect..
Determine the cop of the heat pump and rate : Refrigerant 134a enters the condenser of a residential heat pump at 800 kPa and 35 degrees celcius at a rate of 0.018 kg/s and leaves at 800 kPa as a saturated liquid. If the compressor consumes 1.2 kW of power, determine a) the COP of the heat pump ..
What contour intervals will be drawn if a 50ft interval : An area that varies in elevation from 463ft - 634ft is being mapped. What contour intervals will be drawn if a 50ft interval is used? Which lines are emphasized?
The mass center of the unbalanced disk of weight w is locate : The mass center of the unbalanced disk of weight W is located at G, which is a distance of R/2 from the center for the disk. In the equilibrium postition
What will be the discharge through the pipe : A pump having the characteristics given in figure 14.9 ( N=2133.5 rpm, n=35.6 rps, D=37.1 cm) pumps water at 25 degree C from a reservoir at an elevation of 366 m to a reservoir at an elevation
Find the operating points (q) for one pump : The pump curve for a given pump is represented by hp,pump=20 (1-(Q/100)^2) where hp,pump is the head provided by the pump in feet and Q is the discharge in gpm.

Reviews

Write a Review

Civil Engineering Questions & Answers

  How much must set aside in savings account for the 3-months

Martin pays rent of $500 per month for the 9-month acedemic year, he is going to travel the world this summer and won't be working. how much must he set aside in his savings account for the 3-month summer to cover his rent for the next year

  Elevation of the curve turning point

Set up a table showing curve elevations at the PVC, at the PVT, and at the half-station points along the curve. Compute the station and elevation of the curve turning point.

  What is velocity of blocks 5 after blocks started moving

What is the velocity of the blocks 5.00 after the blocks have started moving. Assume that the rope joining the two blocks in long enough so that, at this time, block A is on the frictionless surface while block B is still on the rough surface.

  Show that potential energy of the compressed gas is given

Let the cross - sectional area of the tube be given by A and the position of the cylinder by s , and assume that the compressed gas is an ideal gas at constant temperature so that the pressure P times the volume is a constant

  Find what is the upward acceleration starting from rest

An elevator weigh 4000kg. When the upward tension in the supporting cable is 48000N what is the upward acceleration Starting from rest, how far does it rise in 3s

  What is the water content of the material when saturated

The dry density of a compacted sand is 1.87 Mg/m^3 and the density of the solids is 2.67 Mg/m^3. What is the water content of the material when saturated. Include a phase diagram.

  Calculate required compressive strength for a concrete mix

Calculate the required compressive strength for a concrete mix design if F'c = 5000 psi and data indicate a standard deviation of 600 psi based on 15 tests for a similar concrete mix

  Determine the force and couple at o equivalent to the two

Head loss and sunshine striking a pipeline cause the temperature of the water flowing inside to rise by 2 degrees Celsius between two measuring points. Find the heat gain in J/N and cal/N.

  Determine the speed of the car when s starting from rest

The 2 Mg car is being towed by a winch. If the winch exerts a force of T=105s on the cable, where 14m is the displacement of the car in meters, determine the speed of the car when s , starting from rest. Neglect rolling resistance of the car.

  Find the required column reinforcement

A rectangular column of size 16” x 16” is to be designed for the following loads. Service D.L = 150 kips ft, Service LL = 200 kips-ft. DL Moment = 80 ft- kips, LL Moment =130 ft kips. Find the required column reinforcement.

  At which the driver could apply the brakes and still stop

The road is in good, dry conditions until 160 ft before the stalled car where it is wet and stays wet for the remaining length. What is the minimum distance from the stalled car at which the driver could apply the brakes and still stop before hitt..

  Explain how to prepare-check and adjust the notes

The plus sight and minus sight distances were kept approximately equal. Readings (in feet) listed in the order taken are 5.06 (+s) on BM tree, 8.99 (-s) and 7.33 (+s) on TPI, 2.52 (-s) and 4.85 (+s) on BM X, 3.61(-s) and 5.52 (+s) on TP2, and 7.60..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd