Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
You've experienced convection cooling if you've ever extended your hand out the window of a moving vehi- cle or into a flowing water stream. With the surface of your hand at a temperature of 30°C, determine the convection heat flux for (a) a vehicle speed of 35 km/h in air at -5°C with a convection coefficient of 40 W/m2 · K and (b) a velocity of 0.2 m/s in a water stream at 10°C with a convection coefficient of 900 W/m2 · K. Which condition would feel colder? Contrast these results with a heat loss of approximately 30 W/m2 under normal room conditions.
If the chest is completely filled with ice, calculate the time for the ice to completely melt. State your assumptions. The enthalpy of fusion for water is 330 kJ/kg.
consider a one-dimensional plane wall of thickness 2l. the surface at x -l is subjected to convective conditions
The water enters the thin-walled tubes at 17°C and is to leave at 57°C. Assuming an overall heat transfer coefficient of 2000 W/m2 · K, determine the required heat exchanger surface area and the water flow rate.
in a water heating system cold water at 5 c flowing at a rate of 5 kgs is mixed adiabatically with hot water at 80 c
Outside cool air at 15C and 40% relative humidity is mixed with inside air taken near the celling in a room at 32C and 70% relative humidity. Determine the relative humidity and temperature of the resultant air stream if the outside flow rate is 40 m..
in a carnot cycle heat is supplied at 350degc and rejected at 27degc. the working fluid is water which while receiving
a belt drive is desire to couple the motor with a mixer for processing corn syrup. the 10-hp electric motor is rated at
Water at 10C and a velocity of .6 m/s flows over one surface of a 1.5 m long flat plate maintained at 44C. Consider the following: Determine the heat transfer rate per unit width (W/m) from plate.
The member has a square cross section and is subjected to a resultant internal bending moment of M = 850 Nm as shown. Determine the stress at each corner and sketch the stress distribution produced by M. Set theta = 30 (dimensions 250mm by 250 mm)
consider an aircraft powered by a turbojet engine that has a pressure ratio of 9. the aircraft is stationary on the
Determine the following for a south facing surface at 30° slope in Gainesville, FL (Latitude = 29.68°N, Longitude = 82.27°W) on September 21 at noon solar time (Assuming a ground reflectivity of 0.2):
Steam at 300°C and 200 kPa is contained in a rigid tank of volume 0.36 m3. The tank is cooled while 350 kJ of heat are removed. Find the final pressure. Show the process on a P-v diagram
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd