Reference no: EM13858648
For the closed-loop control system shown in Figure 1, the design specifications are:
DS1. Zero steady-state error to a step input
DS2. Steady-state error due to a ramp input of less than 0.25.
DS3. Percent overshoot less than 5% to a step input
DS4. Settling time less than 2 seconds to a step input
1. Sketch the admissible region of the s-plane for the closed-loop poles such that DS3 and DS4 are satisfied.
2. Consider first a proportional (P) controller: Gc(s) = K. Check if DS1 and DS2 are satisfied.
3. Consider a proportional-integral (PI) controller: Gc(s) = KP +KI /s. Determine the range of values for KP and KI for which the closed-loop system is stable.
4. Determine an admissible range of values for KI such that DS2 is satisfied.
5. Use rltool to determine a set of admissible controller parameters:
a. Place the pole of the controller and vary the zero such that the system closedloop poles are placed in the admissible region determined at 1.
b. Determine the controller parameters.
6. Plot the system step response and analyze DS1, DS3 and DS4.
7. Plot the system ramp response and analyze DS2.
|
How much consumer surplus is generated at prices identified
: A monopolist firm serves 6 consumers. Each of the consumers only buy one unit of the good. Two consumers buy one unit if the price is lower or equal than $100 and the other four consumers buy one unit if the price is lower or equal than $10. The firm..
|
|
Firm is restricted to set single price for both markets
: Firm C&D is a monopolist both in the US market and in the international market. The demand curve for the US market is QUS = 10 − PUS and the demand curve for the international market is QI =20−PI. The firm’s cost function is C(Q)=2Q+2. Suppose the fi..
|
|
Profit maximizing firm-consider production economy
: Draw the function Y = F(K, L¯) in terms of Y and K, for some fixed L. On the same graph, plot the cost function for renting a certain amount of capital at a rental price of R, i.e. RK. For a profit maximizing firm, illustrate graphically how much cap..
|
|
Prepare the adjusting entries for the month of june
: Post the adjusting entries to the ledger accounts. Enter the totals from the trial balance as beginning account balances - Prepare the adjusting entries for the month of June.
|
|
Determine the controller parameters
: Determine the controller parameters. Plot the system step response and analyze DS1, DS3 and DS4. Plot the system ramp response and analyze DS2.
|
|
Calculate the current flowing through resistor
: Apply Mesh Analysis to calculate the current flowing through Resistor R2 in the below sketch:
|
|
Design practical fluid system
: Prepare young engineers through hands on experience in writing project technical report to execute tasks related to design practical fluid system.
|
|
Evaluate the performance of system
: A rotating machine, such as turbines or compressors, is vibrating and transmitting large forces to the ground. This vibration might be due to shock or unbalanced mass of the rotor.
|
|
Adverse effects on the environment
: Using the textbooks, the University Library, or other resources, answer each of the following questions in 150 to 200 words. 1. Select a fossil fuel. How is this fossil fuel used? What are the adverse effects on the environment?
|