Determine the controller gain kc and the integral time

Assignment Help Electrical Engineering
Reference no: EM13252110

An electronic PI temperature controller has an output p of 12 mA when the set point equals the nominal process tmperature. The controller response to step change in the temperature set point of 3 mA (equivalent to a change of 5 degrees F) is shown below

t,s p, mA

0- 12

0+ 10

20 9

60 7

80 6

Determine the controller gain Kc (mA/mA) and the integral time, tau(sub l). Is the controller reverse-acting or direct-acting?

Reference no: EM13252110

Questions Cloud

What effect will this have on the number in the waiting line : On weekends, the arrival rate can be expected to increase to over 12 per hour. What effect will this have on the number in the waiting line?
Find the thickness of the film : a thin film of alcohol (n=1.36) lies on a flat glass plate (n=1.54). when monochromatic light, what is the thickness of the film
What will be the voltage measured across the motor terminals : Suppose a resistor whose value is equal to the motor resistance is connected across the motor terminals and the motor is spun at 200 RPMs. What will be the voltage measured across the motor terminals
Find at least one other student waiting in line : What is the probability that an arriving student(just before entering the Administrative Service Office) will find at least one other student waiting in line?
Determine the controller gain kc and the integral time : An electronic PI temperature controller has an output p of 12 mA when the set point equals the nominal process tmperature. The controller response to step change in the temperature set point of 3 mA
At what angle will the third order be observed : the first-order line of 571 nm light falling on a diffraction grating is observed at a 17.9 deg angle, at what angle will the third order be observed
Write the equation for the radius of the circle : A charged particle moves in a circle in a magnetic field. (a) Starting with the force relation, write the equation for the radius of the circle
Design a pos circuit with any number of inputs : Consider a 4 input, 1 output digital system (W,X,Y,Z, and f respectively) . Design a POS circuit with any number of inputs such that f(W,X,Y,Z) = M(0,2,4,9,13) + D(6,14).
Find how many different choices of officers are possible : A president, secretary, and treasurer are to be chosen from a group of 10 senior members of the IEEE student chapter at the Citadel. Assume that each member cannot serve more than one position.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate the real and reactive power at the sending-end

A 60 Hz, three-phase, transposed transmission line has the following parameters: Z = 13.114+ j52.952, Y = j0.311/1000. The sending-end line-to-line voltage is 161 kV. The total receiving-end load is represented by ZL =143 with an angle

  Electrical wiring: potentials of neutral and earth wires

Electrical wiring: Potentials of neutral and earth wires, Why is the neutral wire in housing circuits also at zero potential

  What is the impulse response for the system

Consider the following differential equation, where x(t) is the input and y(t) is the output: d/dt y(t)+5y(t)=2x(t) Suppose the input is x(t) = 4u(t) and the initial condition is y(0-) = 6 1. What is the impulse response for the system

  Specify the horsepower required for the driving motor

Air is to be compressed from atmospheric pressure at 60oF to 100 psia in a centrfugal compressor (isentropic efficiency about 0.7). The flow rate will be 500 lbm/min. Specify the horsepower required for the driving motor

  With what speed do waves travel across the cord

A 2.5 meter long elastic cord is fixed at both ends. a) If the cord is vibrated at a frequency of 35-Hz, a n=3 standing wave is produced. with what speed do waves travel across the cord.

  Determine what is the transistors emitter current

1) in a swamped common-emiter BJT amplifier, as shown below, if Vcc =12 V, R1 =8.2 kohm, R2=10 kohm, Rc = 500 ohm, Re= 1 kohm, Vbe = 0.7 V, and B =100, what is the transistor`s emitter current

  Design a signal conditioning circuit using op amps

A wind speed sensor generates an output voltage that ranges between 10 to 55 mV when the wind speed varies from 0 to 120Km/Hr.The output of the sensor is connected to an Analog to Digital Converter (ADC) through a signal conditioning circuit.

  What is the time function of the incident electric field

A 9 GHz parallel polarized wave with an amplitude of 20 V/m is obliquely incident from air (z 0). Theta_i equals a 60-degree angle of incidence.

  How far does sam land from the base of the cliff

Sam (75 ) takes off up a 50--high, 10 frictionless slope on his jet-powered skis. The skis have a thrust of 200 . He keeps his skis tilted at 10 after becoming airborne. How far does Sam land from the base of the cliff

  What is the magnitude of the induced emf per phase in rotor

A three-phase induction motor operates at a slip of 3% and has a rotor copper loss of 300W. The rotational loss is 1500W. Determine (a) The air-gap power (b) The power output (c) If the rotor impedance is 0.2+j0.8 ohm/phase,

  Calculate the value of the voltmeter resistor-rv

A simple voltmeter with a full-scale reading of 50(V) is required. Use a d'Arsonval movement with a rating of 20(mV) at 1 (mA). Calculate the value of the voltmeter resistor, Rv, required to achieve these design specifications.

  How many atoms are there per cubic unit cell

A 3-D cubic unit cell contains four atoms whose centers are positional halfway up along each of the vertical cell edges and one atom each centered in the middle of the top and bottom faces.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd