Determine the concentration in weight percent of v

Assignment Help Civil Engineering
Reference no: EM13316844

Iron and vanadium both have the BCC crystal structure, and V forms a substitutional solid structure in Fe for concentrations up to approximately 20 wt% V at room temperature. Determine the concentration in weight percent of V that must be added to iron to yield a unit cell edge length of 0.289nm

Reference no: EM13316844

Questions Cloud

How much does the package weigh : The scale of a spring balance that reads from 0 to 15.0 kg is 12.0 cm long. How much does the package weigh
Determine the worked deeloped in kj per kg of air : air enters a turbine operating at steady state at 8 bar, 1127 C and exits at 1.5 bar, 347 C. The heat transfer from the turbine to its surroundings is 10 kJ/kg of air flowing through the turbine.
Find the magnitude of the charge on each : The electric field midway between two equal but opposite point charges is 745 N/C, What is the magnitude of the charge on each
Estimate number of raccoons that attempted to cross highway : nighttime traffic on a single lane of rural highway is light, with a flow of 40 vehicles/hour , and is well described by a Poisson arrival process. A racoon dashes across the road, without looking at a speed of 12 mph.
Determine the concentration in weight percent of v : Iron and vanadium both have the BCC crystal structure, and V forms a substitutional solid structure in Fe for concentrations up to approximately 20 wt% V at room temperature.
Calculate what ground distance will be measured : What ground distance will be measured if grid distance is 2158m and Orthometric height = 850m, Scale factor Sf = 0.9999943, Geoidal separation N = 27m, Ra = 6371km
What is the area left ungrazed by the horses : Four horses are tethered at 4 corners of a square field of side 70 metres so that they just cannot reach one another. What is the area left ungrazed by the horses
Determine what is the geodetic az of the line : The grid Az of a line is 142° 25' 18". If the convergence angle is 1° 05' 34" and the arc to chord correction is 2.1", what is the geodetic Az of the line
What are the spcs83 coordinates and convergence angle : What are the SPCS83 coordinates and convergence angle for a station in the Colorado Central zone with geodetic coordinates of 39° 44' 40.74141"N, 105° 00' 07.48466"W

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the probability that a failure is due to disease

Outside factors are related to induced substances (73%) or foreign objects (27%). Natural occurrences are caused by arterial blockage (56%), disease (27%), and infection (e.g., staph infection) (17%). Round your answers to four decimal places (e.g..

  What is the rate of fuel used by the engine in the test

A container of petrol on a set of scales is used to measure the rate at which fuel is used by an engine under test. In one test the weight measured by the scales decreases by 25.0 N in 1 hour.

  What return period must an engineer use in the design

What return period must an engineer use in the design of a bridge opening for a 50% risk that flooding will occur at least once in two consecutive years? Repeat for a risk of 100%.

  Estimate the pressure change over 80 m of pipeline

Water at 20ºC flows at a velocity of 2 m/s in a 200-mm diameter horizontal ductile-iron pipe. a) Estimate the friction factor in the pipe, and state whether the pipe is hydraulically smooth or rough.

  Determine the water depth in the bridge constriction

A river upstream of a brdige corssing is 3 meters deep and has an average velocity of 3 m/s. The bridge piers cause a constriction in the width of the flow by 12%.

  Calculate the re-circulating load in the secondary crusher

A two stage crushing operation feeds 0.6 m diameter ore into a primary crusher at a rate of 25mt/hr. 80% of the ore feeds through an 0.2m screen into a secondary crusher. 65% of the ore from the secondary crusher comes out of a 50mm screen.

  Calculate the speed at impact to a driver at a distance

A large rock became visible to a driver at a distance of 175 ft. Assuming a perception-reaction time of 0.8 s, an initial speed of 42 mi/h, a coefficient of friction of 0.5, and a level roadway, calculate the speed at impact.

  Complete level book entries and calculate reduced levels

Determine the maximum allowable misclose for this engineering survey using the formula based on the munber of instriunent stations used in the work.

  How large of an area would one need to cover with solar cell

Given that the average power plant produces 667 MW of electricity per year, there are 492 coal plants in the US, and a solar constant of 1.361 KW/m^2, how large of an area would one need to cover with solar cells to replace our dependence on coal ..

  Write the general mass balance equation for the rinse tank

To remove the solution containing metal from a part after plating the part is commonly rinsed with water. The rinse water is contaminated with metal and must be treated before discharge. The Shiny Metal Plating Co. The plating solution contains 85..

  Calculate weight of water added to reach the saturation

A soil sample with a volume of 0.5 m3, dry unit weight = 18.1 kN/m3, water content = 5%, and Specific Gravity of the soil solids = 2.68. Calculate weight of water added to reach 90% saturation (in kilograms)?

  Describe the basic principle of differential gns positioning

Describe the basic principle of differential GNSS positioning and the difference between real time differential GNSS and post processed differential GNSS.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd