Determine the closed loop bandwidth of a compensated opamp

Assignment Help Electrical Engineering
Reference no: EM13278114

A compensated op-amp has an open loop low frequency gain of 10^5 and an open loop -3db frequency of 10 Hz. If an inverting amplifier with a closed loop low frequency gain of 100 uses this op-amp, determine the closed loop bandwidth.

Reference no: EM13278114

Questions Cloud

Calculate speed of operation at 4 values of the frequency : A 3 phase, 60 Hz, 4 pole, 440-v (line-line, rms) induction motor drive has a full-load (rated) speed of 1746 rpm. The rated torque is 40Nm. Keeping the air gap flux-density peak constant at its rated value
Explain molina hypothesized that chlorofluorocarbons : Mario Molina for their work concerning the formation and decomposition of ozone in the stratosphere. Rowland and Molina hypothesized that chlorofluorocarbons (CFCs) in the stratosphere break down upon exposure to UV radiation, producing chlorine a..
Determine what are idss and vp for the fet : A p-channel JFET operating at VSG = 0 is connected in series with a power supply V and a resistor R = 10 k. Ithas been found that for V 12 V the voltage across R is constant at 10 V. What are IDSS and VP for this FET
Explain what volume of naoh should the missing equivalence : In the fumaric acid titration, at what volume of NaOH should the missing equivalence point show up
Determine the closed loop bandwidth of a compensated opamp : A compensated op-amp has an open loop low frequency gain of 10^5 and an open loop -3db frequency of 10 Hz. If an inverting amplifier with a closed loop low frequency gain of 100 uses this op-amp, determine the closed loop bandwidth.
What is minimum clock period required for state machine : For a state machine, suppose the propagation and contamination delays of the next state circuit are 20nsecs and 5nsec, respectively. For the registers to store the current state, the propagation delay, set-up time, and hold time are 4 nsec, 2nsec,..
What is the pressure in the narrower region : In a section of horizontal pipe with a diameter of 3.0 cm, the pressure is 100 kPa and water is flowing with a speed of 1.5 m/s. What is the pressure in the narrower region
Describe a passive fourth-order butterworth filter with freq : Describe a passive fourth-order Butterworth filter with cutoff frequency of 2000 radians per second and an output resistor of 1000 ohms.
Explain what is the final temperature of the mixture : If you have 340.0 mL of water at 25.00 °C and add 120.0 mL of water at 95.00 °C, what is the final temperature of the mixture. Use 1.00 g/mL as the density of water.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Function of the hmi in a scada system

This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.

  Resultant waveform of the odd harmonic series

Prepare an Excel graph showing the individual components and summated resultant waveform of the odd harmonic series resulting in an approximate square wave.

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Design a 2-digit 24 second shot-clock

Design a 2-digit 24 second "shot-clock" countdown timer with pushbutton controller.

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

  Draw a relay construction diagram

Draw a relay construction diagram and briefly explain the operation of a relay.

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Impact of electron energy

Briefly discuss the impact of electron energy, electron current and target on the Bremsstrahlung generated.

  Traffic light controller

The schematic of the traffic light controller

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd