Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A circuit has in series an electromotive force given b E(t) = 5sin 100t V, a resistor of 10 Ω, an inductor of 0.05 H, and acapacitor of 2 x 10-4 farads. If the initial current andthe initial charge on the capacitor are both zero, find the chargeon the capacitor at any time t > 0.
An electronic PID temperature controller is at steady state with an output of 12 mA. The set point equals the nominal process temperature initially. At t=0, the set point is increased at the rate of 0.5 mA/min (equivalent to a rate of 2 deg F/min)..
An LVDT is used in an accelerometer to measure seismic-mass displacement. The LVDT and signal-conditioning output is 0.31mV/mm with +/-2cm maximum core displacement.
A carousel, starting from rest, is brought to a full rotational speed of one revolution per 5.00 seconds. The angular acceleration during the process is 0.300 rad/s2. The radius of the carousel is 6.00 m.
Two ammeters are put in parallel, and used to measure an unknown current. The unknown current is determined by adding the readings of the two ammeters. Ammeter #1 can read a maximum current of 50[A], and has a meter resistance of 2.35ohms.
Describe the characteristics of the series RC filter circuit with the output across the resistive component. Distinguish the pass and stop bands with reference to the cutoff frequency. Also, state what happens to the circuit complex impedance at t..
Consider a transmission line with Ro=50-ohm connected to an 850 MHz, 50ohm generator and a load ZL=75 + j10 ohm. Find the input impedance at a distance of 0.2m from the load using a Smith Chart.
b. If the opamp is configured as a non inverting amplifier with voltage gain of 100, what bandwidth will the circuit have c. With the same configuration (gain of 100), what is the maximum input for linear operation (limited by VCC)
The power dissipated in the resistor R0 is 89 W when connected to a 10V source. Find the total dissipated power if 3 resistors identical to R0 are connected in series to a 10V source.
The following equation represents the complete combustion of ethane: 2C2H6(g) + 7O2(g) 4CO2(g) + 6H2O(g)At the same temperature and pressure what is the maximum volume in liters of carbon dioxide
What is the (approximate) maximum electric field intensity for which constant mobility may be assumed for electrons in silicon. In a digital circuit with a supply voltage of 1V, what is the corresponding gate length for MOS transistors.
What is the phase angle of a series/parallel RC circuit with an AC voltage source of 3 Vrms that has a series R1 resistor (100 ohms) and an R2 resistor (10 kohms) in parallel with a 0.1 microfarad capacitor
A multi-frequency signal is input to a first-order, low-pass filter. A 60 kHzcomponent is found to be reduced in amplitude by a factor of 90. Find the break frequency of this filter. determine the factor of reduction for the 5 kHzcomponent.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd