Determine the change of the entropy of the entire system

Assignment Help Mechanical Engineering

Reference no: EM13701635

Ten grams of computer chips with a specific heat of 0.3 kJ/kg dot K are initially at 15 degrees C. These chips are cooled by placement in 5 grams of saturated liquid R134a at -38 degrees C. Presuming that the pressure remains constant while the chips are being cooled, determine the entropy change of the chips, then determine the entropy change of the R134a and then determine the change of the entropy of the entire system. Is this process possible? Why or why not?

Reference no: EM13701635

Questions Cloud

A dragster comes off the start line with an acceleration : A dragster comes off the start line with an acceleration of 4 m/s2. The acceleration increases uniformly from 4 m/s2 to 10m/s2 over 3 seconds, then remains constant to the finish line (500m). Find: a) the acceleration as a function of time (make a gr..

Coefficient of friction between the container and the floor : A 40 kg container is initially at rest and then is pushed by a hydraulic cylinder with a force (kN) = 160 - 10 s. The coefficient of friction between the container and the floor is .26. Give one reason why it may be quickest to use energy methods to ..

Intended target should the supply package be dropped : A pilot wants to drop supplies from an aircraft flying at a horizontal velocity of 300 km/hr at an altitude of 500 m. How far (distance and time) before the intended target should the supply package be dropped?

Determine the total entropy change for this process : A 60-kg iron block and a 39-kg copper block, both initially at 76oC, are dropped into a large lake at 9oC. Thermal equilibrium is established after a while as a result of heat transfer between the blocks and the lake water. Determine the total entrop..

Determine the change of the entropy of the entire system : Ten grams of computer chips with a specific heat of 0.3 kJ/kg dot K are initially at 15 degrees C. These chips are cooled by placement in 5 grams of saturated liquid R134a at -38 degrees C.

Determine the angular velocity after : The 0.6-kg mass is supported by two arms of negligible mass. The angle ? of the arms can be varied by changing the force F acting on the slid- ing collar. When ? = 70?, the assembly is rotating freely about the vertical axis with the angular velocity..

Steam is the working fluid in a simple : Steam is the working fluid in a simple, ideal Rankine cycle. Saturated vapor enters the turbine at 8 MPa and saturated liquid exits the condenser at a pressure of 8 kPa. The net power output of the cycle is 100 MA.

What speed should the wind tunnel be run : A 1/10th scale model of an airplane is to be tested in a wind tunnel that operates with air at a pressure of 20 atmospheres. The plane is expected to fly at a speed of 500 [km/hr]. (a) What speed should the wind tunnel be run? (b) If the drag measure..

Liquid in a tube varies with tube diameter : The capillary rise, h, of a liquid in a tube varies with tube diameter, d, gravity, g, fluid density, roe , surface tension, Y, and the contact angle, B. (a) Find the dimensionless form of this statement. (b) If h = 3 [cm] in a given experiment, what..

User Account

All Pages