Determine the bending moment at the intermediate support due

Reference no: EM13559279

A beam is simply supported at the ends and is continuous over two spans. The left-hand span is 16 ft and the right-hand span is 20 ft. The beam supports a uniform load of 900 plf, which includes its own weight, over the entire 36 ft and also a concentrated load of 10,000 lb applied at a point that is 5 ft from the left-hand end of beam. Determine the bending moment at the intermediate support due to the uniform load only and then the concentrated load only.

Reference no: EM13559279

Questions Cloud

Determine the inside heat transfer coefficient : The specific heat capacity Cp of the process fluid is not known at the mean bulk fluid temperature but is a linear function of temperature, and must be calculated using the following information, Cp at 300K is 1.98 kJ/kgK, and Cp at 400K is 2.65 kJ/k..

Compute the sample mean variance and standard deviation and : For the grouped data acting as of each of the data point in an interval was actually located at the midppoint of that interval, compute the sample mean,variance and standard deviation and compare with the results above.

What would be the concentration of pollutant in the effluent : A lagoon with volume 1,200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100 m^3/day for a long enough time to assume that steady-state conditions apply. the waste entering the lagoon has a concentration of 10 mg/L. Assumi..

What is the maximum tensile stress : A 20-foot long W8X67 is suspended from one end. If the modulus of elasticity is 29,000ksi, determine the following.

Determine the bending moment at the intermediate support due : A beam is simply supported at the ends and is continuous over two spans. The left-hand span is 16 ft and the right-hand span is 20 ft. The beam supports a uniform load of 900 plf, which includes its own weight,

Determine the volume flow rate from the manning equation : Water flows uniformly in a rectangularlined with a glass surface 0.018, channel width is b=10m, the flow depth is y=0.5m ,slope is =0.008 determine the volume flow rate from the manning equation and the critical depth

Compute what is the half-life of this material : After 2.00 days, the activity of a sample of an unknown type ofradioactive material has decreased to 84.2% of the initialactivity. What is the half-life of this material

Describe the type of solution you obtained and clearly state : Using a graphical approach, determine the optimal amount of Space Rays and Zappers that need to be produced in order to maximize profits every week. Describe the type of solution you obtained and clearly state your choice of decision variables, objec..

Estimate the diameter of the small pipe : Fluid flows steadily, at a volume rate Q, through a large pipe and then divides into two small pipes, the larger of which has an inside diameter of 25 mm and carries three times the flow of the smaller pipe.

User Account

All Pages