Determine the average power dissipated in rl in milliwatts

Assignment Help Electrical Engineering

Reference no: EM13249092

For the circuit of Figure the following parameters are given with Vcc = 18 volts DC:

Rs = 0 ohm r pi = 1000 ohm Rb = 1750 ohms

C1 = 10 microfarads gm = 50mS RL = 100 ohms

Ce = 0.1 microfarads Re = 135 ohms C2 may be considered very large

vs is a sinusoidal voltage source of 1 volt amplitude and variable frequency. You may assume that the numerical values of the small signal parameter gm may used in large signal quiescent calculations

Determine the gain of the output from vs to vo at a frequency of 100kHz in dB

Determine the phase shift of the circuit from vs to vo at a frequency of 100 kHz

Determine the average power dissipated in Re in watts at 10 kHz

Determine the average power dissipated in RL in milliwatts at 50 kHz

Reference no: EM13249092

Questions Cloud

Determine cutoff frequency and order for anti-image filter : a dsp system is given with the following specifications: design requirements: sampling rate 20,000 Hz Maximum allowable gain variation from 0 to 4,000 Hz = 2dB 40dB rejection at the frequency of 16000 Hz

Explain and identify the property of gas that is measured : Identify the property of gas that is measured in each of the following: a) 425 K; b) 1.0 atm; c) 10.0 L; d) 0.50 mol of He.

Determine the required shunt resistance : A galvanometer with a full-scale sensitivity of 700?A and a coil resistance of 58? is to be used to build an ammeter designed to read 10A at full scale

Determine the best way to address the potential conflicts : Based on what you found in the e-Activity, determine the best way to address the potential conflicts between a patient's right to privacy and information needed for public health and medical research. Provide specific examples to support your resp..

Determine the average power dissipated in rl in milliwatts : For the circuit of Figure the following parameters are given with Vcc = 18 volts DC: Rs = 0 ohm r pi = 1000 ohm Rb = 1750 ohms C1 = 10 microfarads gm = 50mS RL = 100 ohms Ce = 0.1 microfarads Re = 135 ohms C2 may be considered very large

Explain typical industrial electrolysis cells can produce : typical industrial electrolysis cells can produce approximately 6kg of F2 in a 24 hours day. At what current (A) are these cells operating for this to be true

Find the percentage of the circuits final voltage : A capacitor in a single-loop RC circuit is charged to 57% of its final voltage in 1.3s, Find the percentage of the circuit's final voltage after 4.3s

Analyze the financial and privacy impacts of breaches : Analyze the financial and privacy impacts of breaches to health care information systems and make at least two recommendations for preventing such breaches in the future.

What is the real power-reactive power and aparent power : A manufacturing plant has a 600V, 60Hz supply and the following loads: Lights: 24kW Electric furnace: 4.8 + j6.4%u03A9 with a current of 150A Motor loads, 160kW at 0.8 Power Factor, lagging.

User Account

All Pages