Determine the average normal stress and average shear stress

Reference no: EM13302161

A wood board with a 2in. by 4in. cross section is subjected to a tensile load of 100 lb. Determine the average normal stress and average shear stress developed in the wood fibers that are oriented at 30 degrees with the axis of the board.

Reference no: EM13302161

Questions Cloud

Determine what is the lattice of the structure : A particular unit cell is cubic with ions of type A located at the corners and facecenters of the unit cell and ions of type B located at the midpoint of each edge of the cube and at the body centered position.

Find the intensity of the radiation received by the antenna : A dish antenna with a diameter of 22.8 m receives (at normal incidence) a radio signal from a distant source, find the intensity of the radiation received by the antenna

Determine the volume of direct surface runoff in acre-ft : Determine the volume of direct surface runoff in acre-ft that will result from the following storm. The basin area is 1000 acres. The phi index is 0.5 in./hr. 30-minute period 1 2 3 4 Rain intensity (in./hr) 0.9 0.5 0.6 0.5

Find rotational kinetic energy about its center of gravity : A 12.1-kg cylinder rolls without slipping on a rough surface. At an instant when its center of gravity has a speed of 10.6 m/s, find the rotational kinetic energy about its center of gravity

Determine the average normal stress and average shear stress : A wood board with a 2in. by 4in. cross section is subjected to a tensile load of 100 lb. Determine the average normal stress and average shear stress developed in the wood fibers that are oriented at 30 degrees with the axis of the board.

Determine what is the minimum coefficient of road adhesion : A rear-wheel-drive 3000lb drag race car has a 200-inch wheel base and a center of gravity 20 inches above the pavement and 140 inches behind the front axle. The owners wish to achieve an initial acceleration from rest of 15 ft/s on a level paved s..

Pressurizing the cathode or the anode : Calculate E as a function of O2 pressure sent into the cathode (from 1 atm to 10 atm) for a fuel utilization of 80% and a constant anode pressure of 1.5 atm.

What pressure produces the lift : Compressed air in a car lift applies a force to a piston with radius 5.00 cm. What pressure produces the lift

Calculate constant acceleration a that the cart must have : A train which is traveling at 80 mph applies its brakes as it reaches point A and slows down with a constant deceleration. Its decreased velocity is observed to be 60 mph as it passes a point 1/2 miles beyonds A.

User Account

All Pages