Determine the average normal strain in rubber

Assignment Help Civil Engineering
Reference no: EM13302411

An air-filled rubber ball has a diameter of 6 in. If the air pressure within it is increased until the ball's diameter becomes 7 in., determine the average normal strain in rubber.

Reference no: EM13302411

Questions Cloud

What is the angular frquency of the cylinder rolling back : A solid cylider of mass 9.8 kg and radius 28 cm is yoked to a spring as shown. What is the angular frquency of the cylinder rolling back
Find the interest paid during the first year : For tax purposes, she needs to know the amount of interest paid during each year of the loan. Find the interest paid during the first year.
What minimum length of cable is needed : The cable below supports a unoformly distributed load. The max tension that the cable can withstand is 41 x 10^6 N, What minimum length of cable is needed
How are compacted and loose bulk density used in real life : How are compacted and loose bulk density used in real life. Also is a high degree of accuracy necessary in the bulk density tests
Determine the average normal strain in rubber : An air-filled rubber ball has a diameter of 6 in. If the air pressure within it is increased until the ball's diameter becomes 7 in., determine the average normal strain in rubber.
Determine its greatest distance from the sun : A comet has a very elliptical orbit with a period of 116.1 y. what is its greatest distance from the Sun
How much error would there be in the volume calculation : Assume the actual water temperature for calibrating a 1/3 ft3 measure was 65 degrees F. If you had used a water temperature of 75 degrees F for your calibration, how much error would there be in your volume calculation (both in ft3 and as a percen..
Ethical implications : Think of a situation that you have experienced or heard about that might be seen as having ethical implications.
State concentration of co3^2- need to initiate precipitation : What concentration of CO3^2- is need to initiate precipitation. Neglect any volume changes during the addition.

Reviews

Write a Review

Civil Engineering Questions & Answers

  How is the spent carbon removed from the pressure contactors

Testing has already been completed on the water and the Usage Rate for the carbon is 0.4 pounds of carbon per 1000 gallons of water treated. The required EBCT is 20 minutes and the carbon longevity must be at least 6 months.

  What is the rate of energy in kw that enters into the air

A 40 oF breeze of 10 miles per hour blows over the top of a round open-top water cooling tank which has a bulk temperature of 100 oF. What is the rate of energy in kW that enters into the air

  Radius of the steel wire ehen stretching with other wire

The aluminium wire has a radius of 1.1mm. What must be the radius of the steel wire if it is to stretch the same distance as the aluminium wire, so that the two wires maintain equal lengths after the masses are attached?

  Calculate the minimum flow rate

Calculate the minimum flow rate (m^3/hr) of river water needed to acheive pre cooling hot, pasteurized liquid prodcut assuming that 10% heat is lost to the surroundings during exchange and that the water temp after cooling should not exceed 25 deg..

  Determine the isentropic efficiency of the turbine

Steam enters an adiabatic turbine steadily at 3 MPa and 300 *C and leaves at 70 Kpa and 100 *C. If the power output of the turbine is 2 MW, determine a) the isentropic efficiency of the turbine and b) the mass flow rate of the steam flowing throug..

  Discuss about damp-proofing trenches

Discuss about damp-proofing trenches

  Determine what is the drag coefficient at the cars top speed

A 3000-lb car has a maximum speed (at sea level and on a level, paved surface) of 140 mi/h with 16" radius wheels, a gear reduction of 3.5 to 1, and a drivetrain efficiency of 92%. It is know that at the car's top speed the engine is producing 220..

  Determine height from ground and time at which may pass

Ball A is thrown vertically upward from the top of a 30-m-high building with an initial velocity of 5 m/s. At the same instant another ball B is thrown upward from the ground with an initial velocity of 20 m/s. Determine the height from the ground..

  What is the force between the bar and block d

Block D sits freely on the homogeneous bar and experiences a gravitational force of 50N. Homogeneous bar AB experiences a gravitational force of 25 N. What is the force between the bar and block D?

  How to estimate the concentration of a in the reservoir

The rate constant for decay of contaminant A in the reservoir is k=1.5 (1/year). Assuming the population, discharge rate, and reservoir conditions have been stable for a long time, estimate the concentration of A in the reservoir.

  Determine what is the four lane freeways aadt

A four lane freeway (two lanes in each direction) operates at capacity during the peak hour. It has 11-ft lanes, 4-ft shoulders, and there are three ramps within three miles upstream of the segment midpoint and four ramps within three miles downst..

  Survey with construction applications

The calculation and layout of horizontal and vertical curves should be done only by experienced surveyors and differential leveling measurements

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd