Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Ammonia vapor at 300 K and 1.062 MPa pressure condenses onto the outside of a horizontal tube. The tube has an O.D. of 1.91 cm.
a. Suppose that the outside of the tube has a uniform temperature of 290 K. Determine the average condensation heat transfer coefficient of the tube.
b. The tube is cooled by cold water flowing through it and the thin wall of the copper tube offers negligible thermal resistance. If the bulk temperature of the water is 275 K at a location where the outside surface of the tube is at 290 K, what is the heat transfer coefficient inside the tube?
c. Using the heat transfer coefficients you just found, estimate the largest wall thickness for which the thermal resistance of the tube could be neglected. Discuss the variation the tube wall temperature around the circumference and along the length of the tube.
water enters a condenser at a pressure of 200 kpa and a quality of 0.95. the pressure drops by 25 kpa across the
A cylindrical S-950 alloy specimen is under a tensile stress test. The specimen is 975 mm long. If the tensile stress is 300 Mpa and temperature is at 730C. What is the total elongation after 4 hour steady state operation? Assume the total of both in..
in a steam generator compressed liquid water at 1500 psi 100of enters a 1-in diameter tube at the rate of 5 ft3min.
the lowest temperature that has been achieved is about 1 times 10-6 k. to achieve this an additional stage of cooling
a centrifugal pump can provide a 20-m head rise at 75 revmin. if the rotation speed increases to 90 revmin what will be
How much would it cost to deliver one kilo Watt-hour? How does this compare with the cost of energy from your local electric utility at $0.10 per kilo Watt-hour?
A simplified analysis is applied to a gas turbine engine cycle that has a compression ratio of 8 to 1. The compressor and turbine inlet temperatures are, respectively, 300 K and 1400 K. Values of gas (air) properties are obtained from the Air-gas tab..
1.determine the specific volume of superheated nitrogen gas at an absolute pressure of 678 kpa and -134degc based on a
a student takes a multiple choice exam with 10 questions each with 5 possible selections for the answer. suppose that
air at 80 kpa and 127 degrees celsius enters an adiabatic diffuser steadily at a rate of 6000 kghr and leaves at 100
The rod is stress free at room temperature [20(C (68(F)]; and upon cooling to -40(C (-40(F), a maximum thermally induced tensile stress of 125MPa (18,125psi) is possible. Of which of the following metals or alloys may the rod be fabricated: alumin..
determine the minimum no of teeth required on pinion in order to avoid interference which is to gear with 1 a wheel to
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd