Determine the appropriate values of r1-r2 and rc

Assignment Help Electrical Engineering

Reference no: EM13280355

Design a moderate-gain (Av is close to 10) common-emitter amplifier with stabilized bias including an emitter resistor, but without a bypass capacitor. Use a 2N3904 npn transistor with a +15V dc power supply. The minimum useful bandwidth of the amplifier should range from 10Hz to 100KHZ, and this can be determined by the frequency of vin.The maximum peak value of vin is 0.5V. The specified coupling capacitors(non-polarized) are anticipated to comply with the low-cut-off frequency specification. The load for this amplifier will be another small-signal transistor circuit with an input resistance of 10K, and a resistor will simulate it.
Using only standard resistor values, select Re, and design r1,r2,and Rc for bias stability, a Q point near the center of the load line, and the desired gain. Plot the dc load line on the family of curves to help determin the appropriate values of r1, r2, and Rc?

Reference no: EM13280355

Questions Cloud

Determine which voltage leads and which lags : Sketch the phasor diagrams for the following waveforms: v1 = 80sin(pi*t + 35°)(a) What is the phase difference between v1 and v2 (b) Determine which voltage leads and which lags.

Discuss the difference between a police state and : Occasionally, after a volatile incident between police and a suspect, the community may rally to protest the actions of the police. References to a "police state" are sometimes seen on the protest signs

Why does the price go up when interest rates fall : What is the interest rate should fall to 4.5%? Rise to 8.5%? Why does the price go up when interest rates fall? Why does the price go down when interest rates rise?

State the most likely identity for this paint solvent : An IR spectrum for a sample of this solvent is found to show no appreciable absorbance in the region of 1700 cm-1. Of the given possibilities, what is the most likely identity for this paint solvent

Determine the appropriate values of r1-r2 and rc : The minimum useful bandwidth of the amplifier should range from 10Hz to 100KHZ, and this can be determined by the frequency of vin.The maximum peak value of vin is 0.5V. The specified coupling capacitors(non-polarized) are anticipated to comply wi..

Determine the degree of combined leverage : With each company, multiply the degree of financial leverage times the degree of operating leverage to determine the degree of combined leverage for the two periods.

What is the magnetic force acting on the duck : A duck flying horizontally due north at 14.8 m/s passes over Atlanta, What is the magnetic force acting on the duck

Explain increasing the surface area of mno2(s) : This exothermic reaction is catalyzed by MnO2(s). 2H2O2(aq) => 2 H2O(l) + O2(g) Which of the following will increase the rate of this reaction? 1. Raising the temperature 2. Increasing the surface area of MnO2(s)

Determine the rms value of the voltage : Suppose that a voltage given by v(t) = 45 sin(100pt- 70°) is applied to a 9 O resistance. Sketch v(t) to scale versus time (make sure to put the labels on graph). Find the rms value of the voltage.

User Account

All Pages