Determine the angular velocity w of the wheel

Assignment Help Mechanical Engineering
Reference no: EM13701751

A wheel is rotating at a uniform clockwise speed of 2 rad/s when a variable torque is applied to its shaft at time t=0. As a result there is a clockwise angular acceleration \alpha which increases in direct proportion to the angle \Theta through which the wheel turns from the instant t=0. After 16 complete turns from this time the angular acceleration is 4rad/s^2. Determine the angular velocity w of the wheel when this condition is reached.

Reference no: EM13701751

Questions Cloud

An adiabatic piston cylinder contains : An adiabatic piston cylinder contains 1 kg of R-134a. Initially the conditions inside the piston are 200 kPa and 0 degrees C. An electric heater inside the device runs with constant voltage of 110 V and a constant 0.1A of current for one hour.
Velocity of the bullet and block immediately after impact : A 25-g bullet is traveling with a velocity of 425 m/s when it impacts and becomes embedded in 2.5 kg wooden block. The block can move vertically without friction. Determine a) the velocity of the bullet and block immediately after impact,
What would be the yield on three-year treasury bonds today : Assume the real risk-free rate is 1%. Assume also that inflation is expected to be 1% in the coming year (year 1), 2% in the next year after that (year 2), and 3% in the year after that (year 3). Assume also that the default risk premium, the ..
Determine the velocity of boat after they have both dived : A 90-kg man and a 60-kg woman stand at opposite ends of a 150-kg boat, ready to dive, each with a 5-m/s velocity relative to the boat. Determine the velocity of the boat after they have both dived, if (a) the woman dives first, (b) the man dives firs..
Determine the angular velocity w of the wheel : A wheel is rotating at a uniform clockwise speed of 2 rad/s when a variable torque is applied to its shaft at time t=0. As a result there is a clockwise angular acceleration \alpha which increases in direct proportion to the angle \Theta through whic..
Calculating the present value of a bond : Calculating the present value of a bond) If a corporate bond with a face value of $1,000 has 24 years to go until it matures, has a coupon interest rate of 5.7% and a yield to maturity (YTM) of 4.201%, what should be its price in the bond mark..
A heat engine rejects heat to the atmosphere : A heat engine rejects heat to the atmosphere. The temperature of the atmosphere is 80 F. Saturated liquid water enters the boiler at a rate of 1000 lbm/hour with pressure of 250 psia. The water exits the boiler as a saturated vapor at the same pressu..
How computer systems have changed the accounting : Demonstrate a basic understanding of how computer systems have changed the accounting profession -  they begin to understand the framework of how technology can assist accounting processes.
A supply pallet is dropped from an airplane : A supply pallet is dropped from an airplane that is climbing at 30 degrees with an indicated air speed of 600ft/s while traveling at an altitude of 12,000 ft. Determine how long it takes for the pallet to reach the ground from it's release point.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Cconstant specific heats for air at room temperature

a turbojet aircraft is flying with a velocity of 320 ms at an altitude of 9150 m where the ambient conditions are 32

  The chiller capacity is 500 tons find the refrigerant rate

an ideal chiller uses refrigerant 134a and operates between a low-side pressure of 36 psia and a highside pressure of

  Assume that a jet touches down 170 mph and its speed is

assume that a jet touches down 170 mph and its speed is reduced to zero in 240 ft. assuming a constant deceleration

  If the maximum temperature of the cycle is 2200k determine

consider an air standard otto cycle with a compression ratio of 8. the engine inlet conditions are p100 kpa t290k and

  The temperatures on the faces of a plane wall 15 cm thick

the temperatures on the faces of a plane wall 15 cm thick are 375 and 85 degrees celsius. the wall is constructed of a

  Find the amount of return air and outdoor air in cfm

A building has a calculated cooling load of 24 tons, of which 6 tons is latent load. The space is to be maintained at 72 F db and 50% relative humidity. 15% by volume of the air supplied to the space is outdoor air at 95 F db and 65% relative humidit..

  Consider a piston-cylinder assembly containing 014 kg of

consider a piston-cylinder assembly containing 0.14 kg of air initially at a pressure of 350 kpa. heat is added during

  Heat transfer coefficient h64 wm2k one end of the rod is

a steel rod with a diameter of 2 cm length l25cm thermal conductivity of 50 wmk is exposed to ambient air at 20c. heat

  Te bar had these original dimensions length 10000 in

during a test of a metal bar it was foumd that an axial tensile force of 10000 lb resulted in an elongation of 0.023

  Fully draw shear force and bending moment diagrams noting

derive the equation for maximum deformation of a beam in 3 point bending following steps will be helpfula fully draw

  Initially 1361 kg of steam is contained in a

initially 1.361 kg of steam is contained in a piston-cylinder device at 260 oc with a quality of 0.7. determine the

  An irrigation pump is used to draw water from a reservoir

an irrigation pump is used to draw water from a reservoir and deliver it to an irrigation ditch at a mass flow rate of

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd